Agree with the comment about overdampening. I found that out as I struggled to find the right viscosity oil for the trough. Too low viscosity was like no dampening but when i went to a more viscous oil the highs disappeared. I off set by adding more vta but when I moved, i tried a lighter viscosity and found a good balance. I like the design of the walker for two reasons, I tend to slosh the oil onto the record (specially when I have one too many johnny blues!) and the tapered end along with the adjustable oil level would make fine tuning dampening easier. Not sure of the impact of the end of the arm versus the cartridge end however. So far, I just have a few ideas to try.
New Maplenoll Ariadne owner needing advice
I have recently purchased a maplenoll ariadne. I have tried to learn a little about the table but find very little information. I know the table was discontinued in the 90's but the little i have found indicated it is a very good table. I am interested to learn if there are any tricks or problems to optimizing this table. As most of you probably know, it is an air bearing platter and tonearm. I plan on putting my zxy airy 3 on the arm once I get it set up.
- ...
- 327 posts total
- 327 posts total