New preamp, loss of low freq.?


Hooked up new preamp, and I lost what I think is some low freq slam. Reasoning behind this?
i have been rewarded with the best cleanest, accurate midrange/highs I have ever heard, but did lose some low frequencies.      Normal?  

Sanders preamplifier is the new addition. 

Should i I hook up my equalizer to  smooth out, and add some low freq. 

it it is recording dependent, I still feel I lost some bass when sanders is in the mix. 

Not complaining, this has completely opened up my energy rc-70's, I have never heard these sound so loud, so clear before.   It's I feel I lost a few octaves in the lower register. 

Better? Leave it, I can definitely get used to this sound, as before it was a small bit boomy, maybe I just need time to adjust, and to let the pre warm up for a couple weeks. 

thoughts, recommendations, tweaks? I suppose I could move the speakers a little closer to the wall, this may add a little more bass. 
128x128arcticdeth
George,
Yes, the amp's input impedance is extremely low at 10kohm, and is not a good match for this preamp. But the preamp's output impedance is very low, so an amp with an input impedance lower than 47kohm can be used for testing, correct?

If he can borrow an amp with an input impedance of >25kohm approx., it should be adequate for testing. Your thoughts?
George,
From a design perspective, why does the McCormack have such a low input impedance?
Made by Conrad Johnson, does it have to do with impedances of tube preamps, or ones that CJ makes?