I play a Atmos Blu Ray through my Oppo 105 outputting via the 7.1 channel RCA analog output of the Oppo into a Denon Receiver (again via the RCA inputs)Dolby Astmos must use HDMI connection and set output to bitstream out to receiver/prepro, analog output will not give you dolby astmos, what you get is 7.1 surround decoded by your blu ray player.
NO Side Speakers in an atmos system?
Hey guys I hope you can answer this.
I am looking to build a theater and have zero place to put side speakers. I have the rears and the over heads covered plus the main front three and sub. However my question is this, does my Pre/pro (marantz 8802a) take the signals normally sent to the side channels and send them to the back speakers if there are no side speakers? I would hate to lose two important channels that seem more important than the rest.
Part two of this question depending on the answer from the first.
Should I use the rear speakers as side speakers? Meaning, that I have the rear speakers hooked up to the side speaker terminals of the pre?
Thanks for your help.
Mark
I am looking to build a theater and have zero place to put side speakers. I have the rears and the over heads covered plus the main front three and sub. However my question is this, does my Pre/pro (marantz 8802a) take the signals normally sent to the side channels and send them to the back speakers if there are no side speakers? I would hate to lose two important channels that seem more important than the rest.
Part two of this question depending on the answer from the first.
Should I use the rear speakers as side speakers? Meaning, that I have the rear speakers hooked up to the side speaker terminals of the pre?
Thanks for your help.
Mark
- ...
- 16 posts total
- 16 posts total