Ohm Speakers, thoughts?

My 200 series 3s are in a den that is 2/3 open to a nook/kitchen to the rear. The dimension on the open side is 15.5' x 35' x 8'. The closed-in 1/3 is 12 feet deep instead of 35. It amazes me how well the Ohms handle this. The only qualitative difference I notice from the closed side of the room to the open side is the bass level.

I measure 90db 10' back from the speakers with the Outlaw 990 reading "-10db". This is quite loud (not rock concert loud) but it is near my comfort limits. I've never heard any distortion the few times I've pushed it louder.

I have no idea how to tell how much of the amplifier's 250wpc at the S3's 6 ohms I am using.

Line,

I can claim similar results regarding driving the Walsh 5 S3 and Walsh 100 S3 drivers to high volumes with my system. Never a hint of stress or strain!

This is just a theory, but since the Walsh drivers take a while to break in to best sound, it may not be a good idea to drive them to the limit fresh out of the box, but rather work up to high levels gradually. I tend to do this with most new stuff just to be safe.

MWR0707,

I've heard a lot of good things abut the Outlaw amps. I would probably consider one myself if I had the need.

I don't know a thing about your player, but my understanding is that in general mixed video/audio format disk players are not not up to snuff with comparable cd-only designs, which makes sense. I use a $400 Marantz DVD player in a smaller A/V system with CDs and it sounds good, but I'ved never tried it in my reference audio system. I've used a $600 dollar Denon CD player/recorder in my reference audio system for two years. I am satisfied with it and I suspect I could do better with another CD player maybe, but it has not been an issue for me. The Denon sounds clean, smooth, lively, and great overall! I could easily recommend it for the budget and/or feature conscience. You get two drives and the ability to make essentially perfect sounding recordings to boot.

MWR0707,

The f-5 series 3s are in approx. a 27X20 foot inverted "L"shape room as sketched below with a thinly carpeted solid concrete floor. I do not measure decibels, but I like music to be played at realistic sound levels, including rock music. I push the Walsh 5 drivers as hard as my ears can stand before I stop. I have not reached a point where I notice any ill effect on the sound due to volume. The power level lights on my Carver m4.0t do light to near max levels, but does not appear to run out of juice. You can hear and feel the music throughout the house (~3700 square feet) at this point. Nothing I've ever had before ever came close to being able to produce this level of sonic exhiliration!

------------------
|
|
X X |
------- |
| |
| |
| |
| |
| |
| |

Oh well, my sketch doesn't display very clearly does it?

Suffice it to say the L shaped room is 27' long and 20 wide at the base only. The top portion of the room is only about 12' wide. Most listening occurs within the 12'wide section, though the pseudo-omni design produces a coherent soundstage with not much change in timbre anywhere in the room. No box design speaker can do this. The closest I've come is with front ported speakers with good dispersion sitting right up against the far wall.

I could be wrong about this, but, I was led to believe that Ohm no longer uses Walsh drivers. Perhaps some are actually purchasing the Ohm sound, not the Walsh sound.