Ohm Walsh Micro Talls: who's actually heard 'em?

Thanks Newbee and Mapman, last night I moved the speakers in a bit and the speakers disappeared; I was surrounded by music! Finsup the room size is a bit misleading from my photo. There is the dining room behind where I sit that is one foot above the listening area and extends about 20 feet behind where I sit. Similarly, off to the left, the room opens up into a large entrance way. The ceilings are about 11-12 feet high. So when I crank up the volume I can enjoy the music while dining or I can hear when I'm off to the wetbar on the left of the room. If the room were enclosed, I would have gone with the smaller speakers like the 3000 or 2000.

These are 5000's right?

IF so, then you have the on-board adjustments to match to room size and acoustics so room size should not be a problem.

IF put my 5s with similar adjustments in my smaller 12X12 room just to see/hear how well they worked there compared to my 100S3s, and was able to adjust the 5s to sound very much like the 100s, although the physical cabinet size of the 5s took up too much floor space in such a small room in comparison to the Walsh 2 cabinets where the 100S3 drivers reside.

5000s are taller and narrower than 5s I believe so issues fitting into the room are more likely height of driver related in that in general the Walsh CLS speakers tend to sound best listening at a vertical level at or above drivers, especially if in a more nearfield listening scenario.

Right you are Mapman. There are actually four adjustment switches on the back of the 5000's, one of the selling points for going to the top of the line. The 4000's are actually the same speaker without the adjustment circuits. So if you know the size of your room and don't plan on moving them, John at Ohm can set the adjustment from the factory on a set of 4000's.

...then you have the on-board adjustments to match to room size and acoustics so room size should not be a problem.
--Mapman

The 4000's are actually the same speaker without the adjustment circuits. So if you know the size of your room and don't plan on moving them, John at Ohm can set the adjustment from the factory on a set of 4000's.
--Carja

Can one set the adjustment or does it have to be set at the Factory? It seems, if one can swing the extra coin, that the 5000 is more to be preferred over the 4000 given this flexibility.

Carja - I posted some comments on your system page. When you say you moved them in a bit and were surrounded by sound, does that mean you are getting more depth of soundstage?