Ortofon Per Windfeld Load Impedance?

Independent of length? How come some cable mfgrs change geometry at different lengths in the same model? Res, cap, and ind, are per foot or whatever measure, yes? Surely you lose more than volume (not the word I want) as length increases, particularly with so little to drive it? Like a low output MC. Cartridges that were developed AFTER Fail learned everything... Go slow and use little words please. I read the white papers, I didn't say I understood them...

Amplitude, surely you lose more than just amplitude at longer lengths?

Zieman, the traditional problem with long interconnects is loss of high frequencies. I say traditional because the case of a low output moving coil is a special case. The source impedance of the cartridge is very low- often only a few ohms. Although they don't make much **voltage**, they do make quite a lot of **current**, else it would not be possible for one to drive a 100 ohm load with no loss of output. Try doing that with a tube preamp (the only one I know of that can do that is our own MP-1...)!

So- this is what you have to understand: **There will be no loss in volume, even if the cable is 50 feet!** The source impedance of the cartridge will be unperturbed by the very slight resistance of only a couple of ohms presented by a long cable. The load of the cartridge remains the important variable, and it is here that you will likely hear more difference on account of the quality of the resistor than you will the cable.

You will also hear changes that have little to do with the cable- just pulling the cable out of the back of the preamp and plugging it in again can result in a change if you have any corrosion on your connectors (gold notwithstanding...), plus minor changes that resulted from your messing with the connection at the base of the arm.

This is one of the reasons I like the Triplanar- the only connection is at the cartridge (no removable headshell) and at the preamp- the cable is integrated. The variables of connections are eliminated.

OK, If you're a triplanar fan you must have something going on upstairs. Tri has explained this issue to me in person. Including the limited choices in arm wire. So what is the brand name of this pre?