Passive preamps: What are the relevant numbers?


I'm trying to decide whether I am going to add a passive preamp to my system, but I've been reading that system compatability is very important. What numbers should I be looking at in the specs of my CD player (Rotel 1072), Amp (DNA 0.5) and Interconnects to judge whether a passive preamp might work well in my system?

I know that there was previously a thread about this, but it seems to have been deleted.
davetroy
Dave: the 0.5V you are looking at is the digital output. Line is 2V for most Rotel CDPs - standard. You are fine with a passive pre into DNA - keep the interconnecs not too long and of low impedance.
Well, my wife and I just finished the Bolero Test as described by Arthur Salvatore at high-endaudio.com. Basically, we played Ravel's Bolero directly from the Rotel CD player to the Amp and bypassed the integrated amp completely. Our findings playing Bolero directly from CD player to amp:

1. The volume was much louder than our normal listening level.
2. Better separation of instruments.
3. No seeming lost of bass.
4. Horns seemed to be a little sharper. Brighter?
5. Sound seemed more natural.

We went back and forth a few times. The first time through, my wife didn't know what I was doing and made similar observations to the ones above. I preferred the sound without the integrated amp, although the horns were a bit sharp.

I'd be interested in doing this as a blind test, but we both thought the differences were very obvious. Will placing a passive amp in between the CD player and the amp likely result in similar results?

By the way, as recommended by Arthur Salvatore, we only played Bolero because it starts out soft. I was afraid to do it with another piece of music because the volume direct from CD player to amp was so loud.
There are several different types of passives. There's no real way to know how one would sound in a given system. You'll have to experiment.

Good luck
When you do the "Bolero" test, what are you looking for beyond a potential DC leakage hum/buzz?

I just did the Bolero test, but with different quiet music since I don’t have Bolero. I did not get any abnormal buzzing/noise. It was quite loud which brought out a lot of the recorded "hiss". Do I need to find a quieter recording to tell if this "hiss" is some sort of incompatibility [I am running 2M balanced ICs from my CDP to my amp]?

This hiss is also there when the pre is in the system, but I am not so sure it is the same level of hiss...I guess I need to spend more time on this. The recording I am using is great music, but poorly recorded. I’ll try finding a better recording.