Phono Preamp loading for Hanna EL

Your ears, not others, should determine what is "best"

Yes they are wonderful speakers. And that’s why I can’t part with them. In my opinion the current version,
( legacy Focus SE ) I’m quite confident at the price point there are few loudspeakers that could compete with these speakers. 
Any feedback on legacy speakers would be interesting.

I would have to add that dealing with Bill Dudlesten and his wife Victoria has been a absolutely wonderful experience.There are very few people in your lifetime you will meet like Bill and Victoria...

I tried various settings.  A bit over 400 seems the best in my system.  Some people seem to like it at 1000 though.

But it may be a little too hot or edgy on top. If so this is called ringing, only in this case its electrical, and reduced by loading the cartridge down with a lower impedance

@millercarbon  This statement is only true if its a high output cartridge. The EL is low output and ringing is not why it can sound bright. Ringing at audio frequencies is not a problem with low output cartridges.


The reason is RFI generated by the inductance of the cartridge in parallel with the capacitance of the tonearm cable. This creates a resonant peak which could be a few 100KHz up to a couple of MHz. The peak (which can be 30dB!) is driven into excitation by the energy of the cartridge (it does not have to be at the peak's resonant frequency to do so) and if the preamp doesn't like RFI at its input, it can sound bright (and may generate ticks and pops that sound for all the world as if they are on the surface of the LP, but are actually the result of overload).

The recommended loading is only an approximation. This is because the cable capacitance can't be known in advance. If the preamp is designed with the understanding that there will be a peak at its input in the manner described, no loading will be needed as it will not sound bright. 47K is actually a standard in this regard.


This all goes out the window if a high output cartridge is used. In such a case the inductance is high enough that the resonant peak is much lower in frequency (and usually also in amplitude) and the cartridge can also ring at audio frequencies- this requires that to operate properly, the cartridge will have to see some sort of load. For more seehttp://www.hagtech.com/loading.html