Power Cables which take the soundstage back


Hello,
I have almost always focused on ICs and Spk Cables...but I always knew that Power chords also make a good difference. This is the first time I am venturing seriously into power chords. I am not looking for anything fancy. Primarily I see power chords should be doing the following:

a) Clean up the background noise (because of better shielding etc) which a stock chord would not be doing a good job at.

b) Provide good current capabilities which enables to make music denser, tones get more body and especially bass gets meatier and tighter (the last one normally happens more often)

These are primarily two things I am looking at.
I have tried some power chords in the near past and I have observed one common pattern:

1. Power chords which tighten up the bass (in comparison to stock chords) also bring the images a bit forward.

2. Some Power chords do a good job of taking the soundstage further back...I dont know how and why but I have seen it happening. Some of them end up presenting a bit loose bass in the process (only some of them)

So, for me at this point, a power chord which can take the soundstage back (without introducing anomalies like loose bass) would be a wonderful addition. Thats a very critical requirement for me. I am sure you guys would have experienced power chords which do such things. I am not intending to shell out more than $200 (new or used) at this point. Kindly suggest.
pani
Macdadtexas,
While I apreciate your and others right to an opinion, your assertion that so long as the power is "clean" or if a high quality AC conditioner is present, then little or no gain can be realized from high end (expensive) powercords down stream is false to my ears. This has NOT been my finding on occasions too numerious to mention. In fact I suspect that if I could plug my system directly into the local power plant it would sound better then it does today and if I used my power conditioner and power cords it would sound better still and in the exact same ways it does 10 miles from my local power plant.

As always, and I am sure NO ONE will disagree with this- listen for yourself and then decide. Anyone who tries to talk anyone out of simple listening tests, at home no less, has an agenda. This hobby is about listening to music and getting the most from our personal systems after all.
Shellie, it's funny you bring up a power plant, you see I'm not exactly ignorant of how those work seeing as how I have developed, in a group, greater than 15 power plants over the last 10yrs. That's about 7000 MW of power. That has given me access to a lot of brilliant electrical engineers, and they would tell you that your proximity to the plant would make no differnce since you would need a step down transformer anyway, so that doesn't make any sense.

I no longer work for the company that built them, and I am not an electrical engineer, but I have worked on the design, construction, of all aspects at this point, and I love to bring strings like this to the attention of my buddies who are transmission and power circuit design engineers, it gives them a tremendous amount of pleasure. Your latest post I am sure will be memorialized by them.

Once your power goes from the wall or the power conditioner, as long as the correct volume of electrons, flow into the transformer of the amp/preamp/source then the transformer powers up the remainder of the circuit, tell me again how the power cord affected that? If it is getting the power, enough power to the ciruit the transformer then takes over the power duties. The power transformer can and does affect sound, and the better the gear, usually the better the transformer and the rest of circuit. So if you think your super expensive cord sounds better than a moderate one, good for you. IT'S MAGIC. Did you buy it on Diagon Alley (semi-obscure Harry Potter reference).

Please, could we get a comment from a real electrical engineer here?

Also, I have done this listening test with some very expensive cables, and never heard any difference at all, and power amps used are MASSIVE power hogs, so that should have made a difference.

I usually respect other peoples opinion, unless you are screaming an opinion that makes no sense.

Tell yourself it's better, if it makes you feel better. Hey, I have some land I'd like you to look at too, really great price just for you
Also Shellie, from looking at your other posts, I wonder if you actually work for or represent some cable company, because that is almost exclusively what you discuss. Always the same mantra "buy expensive cables". So, do you work a purveyor or build expensive cables?
Hey Mac,will you help me build my own plant so I can hear the full potential of the valhalla pc that I use with my playstation1?I'll buy the beer!!!
We could put in a GE LM6000, the heat rate is not as good as a 7fe, but smaller footprint. If we do it in Texas or California there is an excellent secondary market for exces power. I'll get a buddy to work up the plans. At about $22 million it won't cost much more than Shellie's power cords.