I'm not sure what the OP's target budget is but I do see mention of a P10 so I'm inclined to think a budget of about $4-4.5K.
Assuming any of the above is correct then I would recommend you give the Torus RM line or Bryston BIT line a close look for your purposes.
The Torus RM20 @ about $3300 will handle 2400VA and is an awesome product. I recently picked one up and it's been impressive to say the least. I am using the RM20 for my Mono Block Amps only which have a load of around 1000VA each @ a 4ohm load.
I'm so impressed with what the RM20 has done in my system that I intend to pickup a RM10 or RM15 now also to cover my front end gear.
I've been running all my gear straight to the wall for YEARS and never felt the need for a power conditioner. I have x 4 dedicated 20A lines in my room. One for each component (total overkill). I decided to try a power conditioner now for several reasons that I won't bore you with. The RM20 is plugged into x 1 of these 20A circuits and it is now responsible for powering both of my amps, which previously, each had their own 20A plug/circuit.
Based on what I'm hearing now I honestly feel the RM20 is providing MORE current to the amps now than the x 2 dedicated wall sockets were before. Seems far fetched but in lookng at the Specs on this unit it's able to supply some serious Juice during transient peaks (400A @ half cycle, 100A for up to 30sec..) which is more then going stright into the wall by a long shot.
Moral of the story, there are other options available I haven't seen mentioned in this thread (until now) that can handle your system requirements with ease. I'll leave one final remark, this is the first time I have ever been impressed with any power conditoner product (I've tried the most popular brand out there more than once whose name I'll keep to myself but isn't hard to figure out) so take my recommendation as you see fit.
Assuming any of the above is correct then I would recommend you give the Torus RM line or Bryston BIT line a close look for your purposes.
The Torus RM20 @ about $3300 will handle 2400VA and is an awesome product. I recently picked one up and it's been impressive to say the least. I am using the RM20 for my Mono Block Amps only which have a load of around 1000VA each @ a 4ohm load.
I'm so impressed with what the RM20 has done in my system that I intend to pickup a RM10 or RM15 now also to cover my front end gear.
I've been running all my gear straight to the wall for YEARS and never felt the need for a power conditioner. I have x 4 dedicated 20A lines in my room. One for each component (total overkill). I decided to try a power conditioner now for several reasons that I won't bore you with. The RM20 is plugged into x 1 of these 20A circuits and it is now responsible for powering both of my amps, which previously, each had their own 20A plug/circuit.
Based on what I'm hearing now I honestly feel the RM20 is providing MORE current to the amps now than the x 2 dedicated wall sockets were before. Seems far fetched but in lookng at the Specs on this unit it's able to supply some serious Juice during transient peaks (400A @ half cycle, 100A for up to 30sec..) which is more then going stright into the wall by a long shot.
Moral of the story, there are other options available I haven't seen mentioned in this thread (until now) that can handle your system requirements with ease. I'll leave one final remark, this is the first time I have ever been impressed with any power conditoner product (I've tried the most popular brand out there more than once whose name I'll keep to myself but isn't hard to figure out) so take my recommendation as you see fit.