My source is Burmester DAC 113 and Blacknote DAC 30
Preamp for Burmester power amp
Hi all, I am new to here. Currently I am using JRDG Capri with Burmester 956 Mk II power amp, to drive ATC SCM40 V2.
I intend to to upgrade the preamp (as I think it’s the weakest part), among Pass Labs XP12, Ayre KX5 Twenty and Bryston BP 17 Cubed, which one u think is a better match with my Burmester?
I intend to to upgrade the preamp (as I think it’s the weakest part), among Pass Labs XP12, Ayre KX5 Twenty and Bryston BP 17 Cubed, which one u think is a better match with my Burmester?
- ...
- 20 posts total
nibongese OP Oh yes!!, but your the one who said it, now watch the pro preamp brigade chuck a mental, and put a hex on your first born. If they have volume controls: If not you’ll need that buffered preamp. The 113dac is 130ohms output impedance so a fine match direct into the 956. The Blacknote even though it’s tube has an output transformer which is a nice low 75ohm output impedance so it’s fine also into the 956. Hopefully you can use their digital domain volume controls at 75% or higher and it’s not too loud, below 75% you’ll start to run the risk of "bit stripping" 16bit 14bit 12bit 10bit ect the lower you go on the volume. Cheers George |
Hi, nibongese, A few years ago I played around with your amp (or was it a previous model?) driving a pair of ATC scm50 (not my spkrs)—coincidence, eh! With the owner, we tried the following pres on loan from shop & friends. Cables were from Nordost. The cd source from Burmester, Ayazi dac (modded; 1st I'd heard of that). We listened to classical, chamber and orchestral music:
(Ultimately, the choice was to trade in the Burmester & buy a used FM pre/power combo... ) Good luck, the fun is in the journey as well as the destination! |
- 20 posts total