PS Audio GCPH and Pass X0.2 not talking?

Audiofeil,

Yep, correct MM/MC are being used. Checked all the gain and impedance settings but nothing makes a difference. It's as if the signal from the GCPH isn't being recognized by the X0.2. Never had this problem with my other preamp.

Audiomax,

Tried that, as noted earlier. The GCPH is definitely putting out a signal when I connect it directly to my power amp. So, it makes no sense why the X0.2 isn't getting an input signal, or outputting it.

Try pluging the GCPH out into the CD input that you are using on the Pass. Gotta work!

Robbyg,

Tried that: Silence.

Me thinks it's got something to do with the signal coming out of the GCPH and how it's being recognized by the X0.2.

Assuming that you have everything thing hooked up correctly. Would you have access to a volt meter? Try to measure the output of your X0.2 at the amp with the GCPH hooked up to one of the inputs (except Phono if the X0.2 has one).
Do the same thing above with your GCPH hooked up directly to your amp. Let us know what you found.

I'd give Pass Labs a call. Assuming that you are using RCA's from your phono preamp to X O.2, did you use Pass's shorting pins in the XLR's? Looking at the unit from the rear, each shorting pin should angle to the right. In other words, from the bottom XLR hole to the top right XLR hole. If the shorting pins are reversed, there is no sound.