Quick fuse question

Now apply that same analysis to the fuse in a pre-amp or DAC.

Next, tell me, if I put in a fuse with higher resistance, will there be less or more noise on the output of the amplifier power supply, and will there be less ripple or more ripple?

if I put in a fuse with higher resistance

You guys have no idea, it’s the resistance that causes it to melt and blow, 🤦‍♂️ go f*****g around with that and you’ll blow your equipment instead, that’s why it’s called resistance wire inside a fuse, if it didn’t resist the over current and blow, your equipment would be toast! leave things alone you have on idea about, really🤔

Anger issues coupled with a lack of knowledge. Charming.

Fuses of the same current rating can vary 5x or more from the lowest resistance to highest resistance at the same operating current.

Perhaps someone without anger issues and potty mouth would like to answer my questions.

Like I said no idea. 

Like I said no idea

LOL I got a great idea. With my little experiment, I proved to myself that the fuse circuit inside a lot of older amps in particular, really limited the amps ability to work propper.. I NEVER had a failure that took out an amp because of a fuse, being moved. I have seen time reset fuses burn equipment to the ground though.. Usually and oil leak, dirty dusty lent and a fuse resetting. You do have to be carefull.

Stereo equipment may seem expensive, when it takes a dump... But there are a lot worse, equipment failures, than stereo gear.

A lot of the new equipment 1/5 the cost of making the things work is digital/analog. 250,000-2.5 million burn to the ground.. FUSES, big dollar fuses..... not run of the mill fuses. Like my buddy George... THINKS..

The world is a LOT bigger than stereo gear, George... Where do you think the ideas for super duper fuses came from....Silly fella...Stereo gear? Not even close....

It came from a need like being in space, or in a tunnel full of coal dust, medical equipment or because something else other than STEREO gear.

Funny guy George.... See no name calling.. just a funny guy...

Regards...