Dover - are you referring to the Original CLS, II, IIa, or IIz? I know the IIa was a bear to drive, due to it's very low impedance. The original CLS actually had a very high impedance above 1000 Hz, I believe. This made it ideal for tube amps. The series II versions definitely favored SS amps.
Recommended Tube Amp for ML CLS I model
Happy holidays!
I've just acquired a pair of CLS I speakers with recent panel upgrade. I know this speaker is supposed to be tube friendly (higher impedance) and the easiest to drive of the CLS range. I am very familiar with the IIz model, but that has very different characteristics from what I understand.
I'm looking to pair a good tube amp with these speakers, to be driven by a Tact 2.2 Mini digital preamp that will be configured to send lower frequency signal to a REL sub and a time-aligned mid / upper signal to the CLS via a Tube amp. (I used a similar setup with an Accuphase DF-35 Digital dividing network and CLS IIz and REL - the Tact is a cheaper option if you just need to 2-way xover division). The digital discussion can take place in another thread.
For now, I am looking for a good tube amp to drive the CLS I model. Since the digitally split signal will be sans deep bass, low frequency performance is not a high priority. So far, I'm looking at ARC VT130SE and VT150 monos (both nice, but a lot of negative feedback used), Rogue Zeus (triode mode), ARC VT100, ARC VS115, Atma-Sphere OTL (with autoformer?), etc.
Any recommendations from those familiar with the original CLS?
TIA!
I've just acquired a pair of CLS I speakers with recent panel upgrade. I know this speaker is supposed to be tube friendly (higher impedance) and the easiest to drive of the CLS range. I am very familiar with the IIz model, but that has very different characteristics from what I understand.
I'm looking to pair a good tube amp with these speakers, to be driven by a Tact 2.2 Mini digital preamp that will be configured to send lower frequency signal to a REL sub and a time-aligned mid / upper signal to the CLS via a Tube amp. (I used a similar setup with an Accuphase DF-35 Digital dividing network and CLS IIz and REL - the Tact is a cheaper option if you just need to 2-way xover division). The digital discussion can take place in another thread.
For now, I am looking for a good tube amp to drive the CLS I model. Since the digitally split signal will be sans deep bass, low frequency performance is not a high priority. So far, I'm looking at ARC VT130SE and VT150 monos (both nice, but a lot of negative feedback used), Rogue Zeus (triode mode), ARC VT100, ARC VS115, Atma-Sphere OTL (with autoformer?), etc.
Any recommendations from those familiar with the original CLS?
TIA!
- ...
- 13 posts total
- 13 posts total