High dampening. There is not a PEQ unique knob. The nonLFE switch setting is 50Hz/24. My only other option is 80Hz/24. I believe the crossover max and rolloff.
Rhythmic F12SE setup using line in
I recently purchased a preamp which has no bass management. I had been using my Marantz 7015 LFE and Audyssey MultEQ-X with a +3db/-3db tilt curve & crossover at 80Hz with my KEF R11’s & Rythmic F12SE. The bass was clear, concise & crisp.
I have followed the Rythmic instructions on line setup and cannot quite get the same results. Bass is less crisp, almost muddy.
I currently have the crossover at 50Hz, gain at 0, bandwidth & freq middle, delay/phase 10:00 (rhythmic recommendation for ported mains), volume about 1:00, nonLFE low pass 50Hz/24, rumble off, extension filter 14 hi.
Any recommendations? Thanks
- ...
- 15 posts total
Interesting recommendation. The KEF’s do come with plugs for the rear ports. I will give that a try, while reducing the crossover. Had a similar recommendation from @soix Thanks! |
I have two Rythmiks of this make. I have done a lot of work to dial in my subs (I have a third REL). Ultimately, the best thing to do was buy a mini DSP and integrate subs that way. Highly recommended. https://www.minidsp.com/applications/digital-crossovers/194-subwoofer-integration-with-minidsp |
- 15 posts total