Solid State Phono Stages


I used to be an all-tube guy, but I’ve now ventured into the realm of high-end solid state with T+A and no longer have any itch to go back heavily into tubes. Now, the only tubes I have left in my system are in my Modwright PH9.0X phono, and from what I’ve demoed against it, it seems to be a giant killer. I do love it, but I’m curious to try a higher end solid state phono stage to see what more noise and more music might sound like. Unfortunately T+A does not have a standalone phono stage, so I’m looking at other manufacturers and open to other opinions.

I currently have a Clearaudio Innovation Wood table and Air Tight PC-1s cartridge. i listen to a wide range of music, from Zeppelin to Vivaldi to Beck to Coltrane to Yello. The stage would ideally have between 65-74db of gain, maybe adjustable to 60db at minimum, and have variable impedance values. A balanced output stage would be ideal. I don’t ever really plan to have a second arm, but most stages that retail over $7K tend to have multiple inputs anyways.

My budget would be at tops ~$8K for a used unit. The unit that is sticking out to me from what I’m reading about is the Simaudio Moon 810LP. Another high on the list is the Esoteric E-02. I’ve also come across the Pass XP-27, the Gold Note PH-1000.

I’m looking for a stage with some personality in its character, not one that is overly refined. I’d love for it to be dynamic and bold when it should be, and also gentle and refined when it should be.

The only solid state stages I’ve ever owned and tried were the Pass Labs Xono, which was clean sounding but a little noisy and brittle sounding compared to a PS Audio Stellar Phono. I’ve liked all my tube phono stages better than both of those units.

I’ve also considered going further up the tube stage route, looking at Doshi 3.0, Aesthetix IO Eclipse, but I’m hesitant unless I can hear those in place. 

What solid stage phono stages have you loved, and what have you compared them to?

128x128Ag insider logo xs@2xblisshifi

Dear @grk  : You came to the thread a little late. The OP already bougth not one but two phono stages. The Audionet is one of them.

 

R.

It’s still worthwhile to hear what folks like, for others’ learning benefits. 
 

@rauliruegas Wouldn’t a RIAA response of +/-0.2db only sway at a max 0.2db at any single frequency? What phono stage do you use that sways a total of 0.11db?

And...I am eagerly awaiting the delivery of his Modwright PH9.0X  

Looking forward to comparing it to my Herron VTPH-1 MC Plus

Dear @thiefoflight  :  +/- 0.2b means that the RIAA deviation has a maximum of 0.2b below or over the eq.  then the swing is 0.4db. In your model that deviation starts at 40hz.

Normally the RIAA deviation spec starts at 20hz and due that Audionet decided to starts at 40hz that means that below 40hz de deviation is higher. Normally too phono stages higher eq. RIAA inverse deviation happens in the low bass frequency range.

You can read about the phonolinepreamp that I'm using in the Agon virtual system.

 

R.