Splitting a balanced signal ???

I split a balanced signal in a Mark Levinson setup years ago to biamp. I bought the splitter at a pro music shop. It worked fine and I didn't perceive any signal degradation. Now there are even high end splitters out there. How many subs are you running? If you are running more than two I think I would run the RCA and use the processor controls to modify gains unless the subs have the controls built in. Previous threads list places to obtain high end splitters. My first choice in your setup would be to not split.

BE CAREFUL!! I had a balanced signal once. I split it and have never been the same. I think i lost my reference to ground.

Sincerely, i remain

Dean, I concur with ljgj. The pro sound guys do it all the time. If you go to a pro musician's shop, they should get you going with the right hardware.

Thanks for the responses. Clueless brings up an EXCELLENT point that i had not thought of recently since i haven't had to deal with such things. As such, i'm extremely glad that he did. It may have saved someone a major repair bill, me included. This may even be related to the problems that he experienced.

Part of the problem with balanced products is that there is no set standard in HOME audio products as to which pin carries what specific part of the signal. Most professional gear follows one industry standard. You have to remember that you have THREE different signals in a balanced cable, not just two. Since there is a lot more involved than just hooking up a two wire cable out of phase, there is more that can go wrong.

As such, one can simply connect Component A from Scamco International to Component B made by Hype Electronics using standard balanced cables and have instant compatibility problems. This is not to mention the potential for actual damage that could occur.

This happens because one manufacturer uses a different wiring pin-out for their balanced jacks and the other manufacturer uses a different scheme. As such, the source supplying the voltages would be connected to the wrong pins of the other component. This could result in short circuits, damaged input or output circuitry, etc...

With that in mind, one should NOT take for granted that "balanced is balanced" and just hook things up. There are different wiring patterns. That is why John Atkinson specifically mentions the pin-out on various balanced products that they test and review. If in doubt, contact the manufacturers of each component being hooked together and record their pin configurations for future use. I would think that most owners manuals might include this info, but as we've seen, some "manuals" are simply a useless photo-copied piece of paper. Sean
>

I don't know about consumer audio equipment, but all pro audio equipment uses pin 1 as ground. Where the issue becomes interesting is that most, but not all, manufacturers use pin 2 as high and pin 3 as low; on the other hand, a lot of old pro recording gear (e.g. Ampex recorders, Dolby decoders), used pin 3 as high. You probably won't mess anything up by connecting them together, but if you find a compatibility problem, you may have to rewire one set of leads.