lalitk, I thought the Monbrisson phono stage did not have sufficient gain for a LOMC cartridge and that it therefore required an external SUT. No? Was there perhaps an option to build in a SUT for LOMC?
Step Up Transformers….Are they Worth the Trouble?
Some of you may aware of my Garrard 301 project, it’s now very close to completion. The plinth finally shipped from Hungry after 3 months of long wait.
Given my last experience with Hana Umami Red, I would like to take things to the next level. Which brings me to mating low output cart with a SUT. Every review I’ve read so far suggests when the SUT-MC match is right, the end result is heavenly. The bass is right, the midrange is clear, and most importantly, the highs are relaxed and extended—not rolled off.
I am not saying you can’t get great sound without a SUT but it appears with a properly matched SUT, sound can be quite magical.
Thought this would be the right time to get input from experienced users here since I am still contemplating my cartridge and outboard phonostage options.
My preference would be to go with a tube phono…I kinda miss tinkering with tubes :-)
My system, Garrard 301 (fully refurbished), Reed 3P tonearm, Accuphase E-650 with built-in AD50 analog board ➡️ Tannoy Canterbury’s.
Cart and phono under consideration through my dealer,
Fuuga - Output : 0.35 mVrms | Impedance : 2.5 Ω (1kHz)
Phonostage - Tron Convergence and Konus Audio Phono Series 1000
The cart - MC combination, I am lusting after is Etsuro Urushi Bordeaux MC with their Etsuro Transformer.
https://www.etsurojapan.com/product/bordeaux
The other transformer is EMIA, cooper or silver version.
Your input is appreciated!
- ...
- 351 posts total
@atmasphere Very Touchy, Thank You for the reminder and prompting myself to state as a Layman. Recorded Music Replay to become an Audio Experience, is dependent on Electric being generated at a source, which is to become a sent signal and managed through a selection of designs for Amplification that is dependent on Math. Where the Math is a fundamental requirement to Amplify a Electrical Signal with the sole intent to convert the Amplified Signal to become a conversion to a different energy type being Sound. How silly of me to let it seem like I was overlooking this area of importance I have plenty of 'over the dam' experiences with Sales Persons. My assessment is that in their view, they are 'always right' in their own opinions and those shared are some sought of Gospel. Lucky for them they are not written as these opinions are very short lived, or last as long as the next best of the best arrives on the shelves. Sales Persons are able to make very interesting claims for Sale Items, at the time of seeking a Closed Won. This biased encounter is one I have been proactive in avoiding. I have removed encounters with at work Sales Persons from my Audio Experience for many many years passed. I am quite willing to meet with Sales Persons who do/have made a living from Audio Equipment sales where a Social Activity is occurring in relation to Audio experiences. In general the individuals I meet frequently / infrequently are liked by myself and a pleasure to spend time with. Where Sales Persons fall very short, is where they can't sell to everybody met. Even when professing their bias and declaring designs promoted as being the best of the best. Such declarations are not enough, end sound for a large group of individuals really does mean something to them, especially when narrowed down to where it becomes important to be entertained as result of experiencing sound resulting from recorded music being replayed. Audio Devices no matter how well designed, how accurate the Math, when encountered and is perceived as producing an end sound that is very unattractive, for many the only want left for the experience, is to end the experience hastily. Sales Persons do not have the monopoly on how one perceives sound produced from Audio Devices. I have been in agreement with Sales Persons when met, either at a place of work or socially. Where I agreed the device selected for a Demo' looked very attractive as a design, and the Control Knobs were a Bespoke design not typically seen. I'm not sure how these attributes to the product, would entertain myself for a prolonged period where the Sound Produced is the entertainment being sought.
|
@pindac Could you explain the 'Very touchy' remark? I was simply pointing out fact. Did you take it differently? This is nothing to do with sales FWIW. |
I have a experience of experiencing quite a lot of equipment in use across quite a few different systems, but must admit today, commercial orientated systems where a system is built to create sales are not listened to much, very infrequently will be a fair explanation since Covid Times and infrequently will be a fair explanation for a good period of time prior to Covid. I can't Speak for all, but have even received reports from individuals I trust in heavily in relation to Audio Equipment, who on return from Event such as the High End Munich, have felt the Demo's encountered overall were uninspiring. There is not a generic formula for Math, that is able to be used that will win over all with the End Sound Produced. Is this not another fact worth pointing out. Foot Work, Experiencing and assessing impression made of an End Sound Produced, is my methodology. It has served me very very well, not much that has been bought has been replaced or resold. Those who have tried to convince me of the Math, are usually informed to leave that for the Mathematicians or Wannabe Mathematicians. During my time and limited encounters, my real trust count in individuals with a Mathematical prowess, that has slowly developed into trust over many years of encounters, is limited to reliance on a number of trusted individuals that amounts to less than the digits on one hand. |
@pindac WTF are you talking about? It seems you just babble about everything that you have heard, at places other than your own. 98% of the time I don't bother reading your posts anymore. Is it just me? I think not. |
- 351 posts total