Stepping up to Air Line Arm?

Something tells me Whart's 1790 home, a splendid one I'm sure, might not favor a 1 ton block of granite on the top floor, in which case me might find it in the basement. However, if the wood floor is a bit bouncy, an active air isolation platform or similar may be the way to go. While the Stabi S is suitable for a wall shelf, the much higher mass of the Stabi XL probably precludes that. The XL is deserving of the best support, and mass loading is recommended where feasible.

OK, here's my compromise right now, with the concerns some of you expressed clearly in the forefront of my mind. The folks at finite elemente were kind enough to credit me what I paid for the Master Reference wall shelf toward the heavy duty (rated 120 kg) set up that is a low floor stand with a bottom shelf for bracing and the top for the TT. I will spike it. It is pretty massive itself, and with the XL on top, will be quite heavy. Although the Stabi Ref is a suspended design, I have temporarily been using it on an old target floor stand (while awaiting delivery of the now aborted Elemente Wall Shelf) with nary a problem.
The floors in the room are relatively new- since the entire top floor of the house, including joists and flooring, was rebuilt by the prior owner about 5 years ago.

If there is a problem, I'm told that the HRS isolation platform could be used on top of the finite elemente stand- even though that sounds like it might be overkill. So, for now, I'm gonna try the finite elemente stand, straight up.
I am reconfiguring the room as well, in a way which will allow me to install the compressor for the Air Line arm in an adjacent closet, and run the hose through a small cut-out in the wall.

I have also found an old brass surgical lamp- like the ancestor of the thing you see at dentist's offices- which has been rewired and will be mounted above the turntable for light, and for drama. I am excited. I should receive the TT Saturday, the stand late next week, and in the meantime, my electrician has just installed a new subpanel, all the way 'upstream' with Square D breakers, and will route 3 dedicated lines to the new area in the room where the equipment will be installed. I should be in business in about a week to 10 days and will report then. You guys are great. Thanks for your feedback.

My ftriend,a serious audiophile/music lover,collector,had a heavy table/Air Tangent arm,mounted to great effect on an active air isolation system.This sat on a heavy floor stand(300 lbs,when loaded with lead shot).He has a 75 year old home,with wooden flooring.The air platform was a BIG improvement!

Best!

One can specify wall shelves that will support 160kilo plus, but of course its vital they are built into brick/stone walls or structures which are load bearing. I'm not sure what type of mass loading you're referring to that would be suitable for suspended wooden floors. You can see a picture of a Kuzma XL on a wall shelf in the Living Voice/Definitive audio piece on 6moons.com.

EBarker- I saw the pictures on the 6moons site of their visit to Definitive UK, and sent Definitive an email inquiring about the source of the wall rack, which looked like a simple affair. Unfortunately, I'm not sure I have a brick wall in the room to support such a rack.

Hey, if it doesn't work, one of you might want to buy an finite elemente floor stand, almost untouched by human hands? :)