Hmm yeah well looking at specs for your mains which go down to 32hz and the 10” sub which only goes to 25 hz, on paper, it does not seem like the sub adds much. Maybe in a larger room and/or if main amp is underpowered to drive the speakers to their full capacity. Also relatively few recordings will have enough going on at those frequencies to tell. Sounds like a tough task with very marginal benefit at best. Losing the sub may not be a bad idea. You probably do not really need one.
Subwoofer. Great one song. Not so great the next song.
I'm not a subwoofer guy. Played around with one in my primary system (Aerial Acoustics 7Bs, Proceed 250w amp, AR LS-16 tube preamp). Big B&W powered, not sure which. Didn't think it added anything. Ditched it.
Recently got a pair of Aerial Acoustic 6Ts for my secondary system. They have no place to be but right up against the wall. Maybe a foot out. Can't decide if they sound better with a sock in the rear facing bass port or not. Its a wash. Overall they sound pretty dang good though.
But, I played around with a JL Audio e110 sub. Pretty nice unit. Put the socks back in the bass ports.
On some songs the combo with the sub just sounds stellar. On others it sounds boomy and thumpy. My audiophile hang up is taught, clear, concise bass. I do not like boomy and thumpy at all. I can get up and turn the output on the sub down a little and it sounds okay again.
But I don't want to do that every time a different song comes on.
Now, on this sub you can change crossover frequencies, phase and also a polarity switch. I don't know _anything_ about that stuff. I've got it set on the more or less default settings in the manual. The only thing I've messed with is the polarity switch and for reasons I don't understand it sounds better on 180 than 0. I have not messed with the crossover frequency and phase dials.
Is there any chance that changing any of those settings would allow me to reach a sweet spot where I don't have to change settings on the sub frequently? I may or may not keep this sub. If I can't find that sweet spot I'll let it go as alone the 6Ts don't sound bad by any measure.
Thanks,
George
Recently got a pair of Aerial Acoustic 6Ts for my secondary system. They have no place to be but right up against the wall. Maybe a foot out. Can't decide if they sound better with a sock in the rear facing bass port or not. Its a wash. Overall they sound pretty dang good though.
But, I played around with a JL Audio e110 sub. Pretty nice unit. Put the socks back in the bass ports.
On some songs the combo with the sub just sounds stellar. On others it sounds boomy and thumpy. My audiophile hang up is taught, clear, concise bass. I do not like boomy and thumpy at all. I can get up and turn the output on the sub down a little and it sounds okay again.
But I don't want to do that every time a different song comes on.
Now, on this sub you can change crossover frequencies, phase and also a polarity switch. I don't know _anything_ about that stuff. I've got it set on the more or less default settings in the manual. The only thing I've messed with is the polarity switch and for reasons I don't understand it sounds better on 180 than 0. I have not messed with the crossover frequency and phase dials.
Is there any chance that changing any of those settings would allow me to reach a sweet spot where I don't have to change settings on the sub frequently? I may or may not keep this sub. If I can't find that sweet spot I'll let it go as alone the 6Ts don't sound bad by any measure.
Thanks,
George
- ...
- 37 posts total
- 37 posts total