Tascam DA-3000

Al:

I do have oscilliscopes and RF spectrum analyzers and I can assure you there is no RF leaving my Spectral preamp. The Spectral also has a special protection monitoring circuit that is designed to pick up RF leaving the amp. That circuit is not or has ever been active. Plus, I am pretty certain that RF feeding a JC2 would not result in good sound through the rest of my system.

Read my recent post on using the Benchmark ADC USB1. I won't repeat that other post here, but basically the Spectral was coupled to the Benchmark which fed digital AES/EBU to the Tascam. If Al is right, the same RF would have been transmitted to the Benchmark and the sonic results would have been the same.

But they were not. There was a dramatic improvement in sound quality (and yes, even through the headphones), so I am not buying the mystery signal theory.

Clearly, the Benchmark has a better designed and implemented analog front end than the Tascam, and one would expect it given the components used by Benchmark.

Components DO matter, and there is a general consensus that some opamps are better than others, and that copious capacitor coupling with electrolytic caps does impact the sound. Why else do people pay $300 for a Mundorf coupling film capacitor? It is also reasonably agreed that an AD797 will sound better than a NE5532.

There is no mystery here, and we don't need to make up theories of mystery RF signals to explain the observed differences.

Fair enough, Dhl93449. Your post just above solidifies your case persuasively, as far as I'm concerned. My theory was an attempt to reconcile your sonic assessment of the Tascam with Jeff's (whose opinions command great respect in my book), while taking into account the nearly unique ultra-wide bandwidths of the Spectral products.

One minor nit, though:

I won't repeat that other post here, but basically the Spectral was coupled to the Benchmark which fed digital AES/EBU to the Tascam. If Al is right, the same RF would have been transmitted to the Benchmark and the sonic results would have been the same.

My theory revolved around the assumption that the anti-aliasing filter in the Tascam was less than fully effective at RF frequencies, perhaps because the design is such that some RF frequencies might bypass the filter altogether via unintended/parasitic circuit paths. If so, the results would very possibly not have been the same with the Benchmark.

Regards,
-- Al

Hi Al, I will have to get either the Benchmark or the Ayre and see for myself. I will let everyone know. The best Jeff

Al or anyone else are you going to CES this year? I am and would like to meet some of you.

Jeff, thanks, but no, I don't have plans to go to CES or any of the other major shows (e.g., RMAF) in the foreseeable future. In part because I'm on the east coast.

Best regards,
-- Al