Thiel Owners


Guys-

I just scored a sweet pair of CS 2.4SE loudspeakers. Anyone else currently or previously owned this model?
Owners of the CS 2.4 or CS 2.7 are free to chime in as well. Thiel are excellent w/ both tubed or solid-state gear!

Keep me posted & Happy Listening!
128x128jafant
@thielrules

Music Reference Amp designer, Roger Modjeski, has been pointing out on a thread in the amps forum something I think we often forget: that most audiophiles often overestimate how much amp power they actually need. Most are barely using the power available in their amps, given typical listening levels. It often takes some significant volume to get them out of a couple watts. I tend to listen when sitting in front of the speaker to an average level of 70 to 75 db at most (though I crank it up when listening from another room). Apparently, my amp would just be cruising, barely breaking a sweat at those levels, even though I’m using a 140W tube amp.


I also have never noticed any sense of strain when I turn it up louder.Now if I truly cranked it REALLY loud levels, it could be a different story.  But, as I understand it, if one’s listening levels aren’t terribly loud to begin with, then there’s no reason lower powered amps should be a problem on Thiels or many other speakers.


(I sometimes use my Eico HF81 on my MBL speakers which are a brutal 82 dB sensitivity, and it sounds plenty good to me, no strain that I notice).

There are of course other variables to consider: current, damping factor, bass quality, possible impedance interactions, the type of music one listens to in terms of dynamics/peaks and how loud. But in terms of sheer power, from what I understand, there’s not mystery why tube amps, which are so often much lower power than one can find in SS amps, often sound good with Thiels.




@thielrules, I measured my 3.7s with a single Cambridge 840w because I felt the bass was lacking.  I did it using test tones and my Behringer ultracurve and measurement mic.  The weak bass didn't show up in the measurements as it measured fine.  I bought a second identical amp to run bridged mono and the bass improved significantly.  The power went from 350 watts/channel into 4 ohms to 800.  The difference wasn't in the volume of the bass but in transients and texture.  As far as recordings go I'd find some with sustained, textured bass and also some with deep and punchy bass.  

This is Edgar Meyer playing his bass with a bow.  Lots of texture.
https://www.youtube.com/watch?v=QcXQcsAOx0I&list=RDQcXQcsAOx0I&start_radio=1

Lots of sustained synth in this silly and possibly creepy eighties music video from Queen
https://www.youtube.com/watch?v=NeL25_Ee5A0

Prof, "...most audiophiles..." aren’t running steady close to 2 Ohm loads, or in my case a steady 4 Ohm load with a 12 dB bass boost eq (albeit with an 8 Ohm impedance bump up at that region).

What might seem like copious power into 2 Ohms when compared to 8 Ohms; really isn’t. It’s not all about sheer volume levels, but rather about ideal operating conditions.

tomthiel brings up a good point about "sweet spot" or best value. For instance my previous declaration in favor of the Bryston 3B (within appropriate matching with older Thiels) was based upon such a criterion. It's not necessarily one the best sounding amps, but at it's price point it performed quite admirably for the task at hand at the time. Which is quite an accomplishment! It's a lot easier to make a cost no object good sounding (and unfortunately enough examples of the over priced / under performers exist as well) kit, than one that performs nearly as well for quite a bit less.
Since we're talking about amps again: some time ago I posted a plea for a list, however small, of amps that by spec would be completely capable of matching the low impedance needs of the Thiels. Has anything materialized? I mean, besides the Krell FPB 600. Seems like we are stuck in "I like the sound of it, but..." land.

Thanks for any input.