To Fuse or Not to Fuse... That is the question!

Observation, I.e., empirical evidence, is equal to measurements as part of the scientific method. So are curiosity and spirit of investigation. Hey, what’d ya know, there’s that word science again! My bad! I did not invent reality nor do I care very much if my Logic fails to convince anyone. Science has become a little bit flabby and stodgy and slow. I prefer to go my own way. Things get done faster that way. I probably broke three laws of physics this week and the week ain’t even over yet. I’m not trying to set the world on fire, just start a flame in a few hearts 🥰 But as Bob Dylan says at the end of all his records, good luck everybody! 🤗

Not according Wikipedia. Do you know something Wikipedia doesn’t? 😳 HiFi Tuning, for one example, employs a 99% silver alloy 1% gold tip to tip, including end caps. Don’t forget the end caps! 🤗 Isoclean uses copper alloy wire and gold plated end caps.

Wiki - The fuse element is made of zinc, copper, silver, aluminum, or alloys to provide stable and predictable characteristics. The fuse ideally would carry its rated current indefinitely, and melt quickly on a small excess.

If you do use a fuse , on synergistic research, You install going with the lettering Left to Right as well as Hifi tuning they have an arrow.
to know how it will sound best very easy going to the positive legg
for example , looking at the IEC input ,if the ground which is the single terminal of the 3 ,if it is on the bottom then your positive terminal will be on the Right
just the opposite if the ground is upside down, this way you don’t 
have to try it both ways the Positive legg is best. Inside you want to go from a connector or terminal to where the electricity is flowing to down stream at the 1st stage if you will. Hopefully this will save someone time from having to figure it out.