Tonearm / Catridge matching?


I have a potentially stupid question about tonearm in general, and linear tracking arm in particular. I am using the Rockport 6000 tonearm, and in his reviews, Michael Fremer had repeatedly stated that the 6000 sounded excellent, but a little weak in the bass. He stated that “ The 6000’s relatively low vertical effective mass put its resonance frequency above the ideal 8-12 Hz region with moving coil cartridges of average weight and typically low compliance, causing the bass to begin rolling off prematurely”. He also stated that Rockport had solved this problem in the 7000, and the arm on the Sirius III, by using heavier armtubes.
Now, if the objective is to make the armtube heavier (so it has a higher effective mass), and assuming the armtube is already rigid enough on the 6000, can I simply add a little lead spacer between the cartridge and the headshell to increase the effective mass and achieve similar result. If this method is workable here, does it also apply to fix pivot arms. Am I missing something here?

Thanks in advance

Michael
thekong
Hi, Thom, Raul, and Nsgarch,

Thanks for all the information. I am using a VDH rebuilt Koetsu Rosewood with my Rockport 6000. Actually I am not feeling that the combination has any bass deficiency at this point, but I, as most of you guys always look for ways to improve the system.

In his review, MF had stated more than once that he liked the 6000 very much but had to give it up because of the bass. That got me thinking, if the only objective is to increase the mass, it should not be that hard to do. It may be hard for an end user to decrease the mass of an arm, but adding mass should be easy. I just want to check with all the experts here before doing anything stupid

I will probably get one of those test LP to see what the resonance frequency of my system is right now. So, other than changing the material interface between the cartridge and the headshell, is there any potential down side with this “fix”?

Thanks in advance

Michael
Increasing effective mass will in theory cause greater problems when tracking warped records. The higher inertia of the arm in the vertical plane will cause a greater swing in effective VTF at the top and bottom of warps. How much this will effect you in reality depends on the warp tracking capabilities of your rig, and of course on your records! If your Rockport has vacuum hold-down then it's probably a non-issue.

Adding the weight on top of the headshell may be better, as Raul suggested. Not only will your cartridge/headshell interface be unaffected, but your VTA/SRA will too. If you put a shim between headshell and cartridge, you'll have to raise your arm by a similar thickness to compensate.

Read Twl's HIFI Mod thread for a very thorough discussion of the positive effects of increased eff. mass on bass and dynamics. His mod was designed for certain pivoted arms, but the principles are the same in many respects.
While we have some expertise on the line, I'm trying to go the opposite direction. I have a Grado Reference Sonata on a Graham Robin with a resonant frequency of 8.5Hz. Two questions come up: Will reducing the tonearm mass help reduce the substantial infrasonic signal, and if so, does anyone manufacture a very lightweight headshell?
Pittsflyer: according to the interactive table at cartridgedb.com, your Robin tonearm (effective mass 11gm.) combined with your Grado cartridge and mounting hardware (6.5 gm + ~1.0 gm. = 7.5 gm.) with a compliance of 20 x 10-6 cm/dyne, gives you a system resonance of 8 hertz. Quite acceptable without any alterations to arm or cartridge.
What about a Grado Reference on a RB300 is it a good match and can any of the above tweaks improve things?