Try a different turntable?


Ever since getting into audio, I've owned a VPI turntable (HW19 upgraded with heavier platter, SAMA, JMW arm). It sounds good, without question. But I've been curious about other TTs that (folks say) come from a different design philosophy--Linn and Rega are often mentioned in this connection.

For the next two years, I am in the fortunate position of having two stereo systems; then I will retire and consolidate into one house and one system. I've set up my second system except for vinyl. What 'table/arm combos would folks recommend as an alternative to the VPI (at about the same price)? Ideally also it would be a tad smaller than the big VPIs since I have less space in the retirement home.

I listen to a little of everything, but like acoustic music (classical, folk, jazz) best, and am looking for a setup that will really connect with the music.

Thanks for suggestions!
magister
Mickeyf, where do you find "actual measurements ... using conventional testing equipment" of turntables in ANY medium these days? Yeah, I use an idler TT (replinthed Lenco) after it totally destroyed an early VPI TNT. And I loved that TNT for years.
"...and suggest you were pre-conditioned..." Well this amounts to calling me non-objective - you need to have hard evidence before you do that!!! Given this accusation, I'll "stick my neck out" and say you're the one being non-objective and therefore dogmatic in your stance. This is my last post on this issue.
Canam ,

With a high mass platter and big motor the word "Torque" comes to mind with BD, TT and or any TT for that matter.

An idler cannot compensate unless it's motor has a closeloop/ servo/speed control system..

Regards,


I would love to hear from someone who has only changed the TT, same armboard/amr/cartridge combination.