Tube Amp vs Solid State Amp HELP

 the hiss is normal for amps of that caliber. it could be a pre tube but i doubt it. your tweeter is in no danger unless you overdrive the amp and even then i doubt it would be blown. not sure if that jolida is amp enough for those speakers to start. speakers with such modest sensitivity numbers need some more power and may be a ss amp is your best bet. never heard them tho so... i think it would sing with a typical 50 watt ss amp and above

+1 veroman. I thought I had posted similar thoughts yesterday. Must have not pushed the post button. A quality 40-50wpc SS amp would best suit your needs and budget. 

Ok, now I'm worried about the FX-10 damaging my speakers. I was reading the Dali manual and it was discussing how a small amp will have more high frequency information and will put a strain on the tweeter. Does this strain only occur if you push the volume too high, or does it also occur at a moderate listening level.

The problem occurs when you clip (overload) the amplifier. When the amp is overload (distorted) the distortion has a lot of high frequencies at high power and the tweeter only handles a few watts, so it can be damaged. As long as you don't overload the amp you will be fine.

A "tube roll" is a sandwich made up of mostly broken glass and little metal bits that, really, should only be eaten by trained side show magicians.

Tube amps are warmer SS amps have better detail and highs(the real good ones).