Unipivot and suspended TT?

Stanwal, I don't know if your response is to my post or something you were just adding to the thread.

I agree the mass of the tonearm is detrimental in the situation you list but I assure you incorrect azimuth is very audible and difficult to get perfect when you have a floor and/ or turntable that frequently go out of level.

I simply meant that heavy arms are often incompatible with lightweight tables. Being a VPI dealer I can see how heavy their arms are and as they are probably the most common unipivot arm I suspected someone had tried to mount one on a table that was too light. There is nothing about a unipivot arm that would prevent it working with any table that it was physically compatible with. I am probably one of the few left who used the Pickering unipivot arm, which was a steel spike resting in a plastic cup on the arm, seemed to work then. I had the Transcriptors fluid dampened arm, which was probably the first one of it's kind. As well as the one [audio & design?] which rested in a mercury bath, no wires as the mercury was suppose to conduct the signal. I was smart enough not to set the last two up as they were Rube Goldberg on steroids.

I am currently using a Scheu Taco arm (unipivot), mounted on my Avid Volvere deck with no issues, for the contrary - I witnesed every single word from a review I read some weeks back where a Naim ARO arm was compared vis-a-vis with an SME, the reviewer found a more musical, liquid and non-mechanical sonic reprodiction from the Naim arm vs the SME fixed pivot design.

Mingles, You've heard my VPI HW19IV/Moerch UP-4 setup so you know the combo of suspended TT/unipivot arm can sound very good.
You should mount your Haddock and invite me over for a session.

Many thanks for your responses. It sounds like the Hadcock is worth a try.

Richard, your VPI is so stiff I forget that it's suspended. The Delphi has a much greater range of motion. It's almost bouncy. I just ordered the maintenance kit from Oracle. Hopefully it will tighten things up. I'll definitely have you over when it's up and running.

07-18-09: Albertporter
I've run several unipivot arms on suspended tables and they can certainly sound great. I think the controversy arises from the fact that if the table is less than perfect level, the azimuth of the arm is off by that same amount. A unipivot arm seeks level based on gravity, not by it's bearings or where the turntable is sitting.

This seems to be the crux of the matter... keeping the table consistently level so the azimuth is on target. I may have a problem achieving this with my suspended wood floors. My tables are currently on a bookshelf and I hear thumps from footfalls. I probably need a wall mount to get the best performance. Any thoughts on this?

Thanks again,
Mark