Upgrading from Kharma 3.2 to Verity Parsifal

Very nice to hear that you are user of Sarastro.

If for Parsifal ( Encore / Ovation ) the following is of
100% certainty. For Sarastro, it is certainly true if you
are not using bi-wire or bi-amp

See if you can change ( up-grade ) the factory-supplied
Jumpers with Siltech Emperor G6 ( SATT VER better )
Jumpers. For the USD 1800- 2000 spent on Siltech Jumpers
I can assure you get back not less than USD 10,000 of
upgrading rewards. I had tried audio Note , XLO Limited Edition Jumpers, Venture Ruby Jumpers, all beatened in
3-4 notes heard. you will "Vow" again once you put
on the Emperor Jumpers.

I had used them for 3 years or so, friends are bringing
other brands to compete, all wnt home with heads down.

Dpang233 thanks for your info, Ill try to give them a listen. But with a little more money I can get one more set of virtual dynamics revelation 2 cable set and run the Sarastros with true bi-wire. I suppose that would be better wouldnt it?

Hi Argyro

I am no fans for Bi-wiring
My opinion is that for the double of speaker cable costs
I would rather use the same money invested to buy
a much better speaker cable + jumper.

If you believe all the Merit of Cables ( inter-connects /
speaker ) minimizing Loss as well as shield-out interference is the importance, why use 2 set of cable of
lower grade . Why not one much higher grade, unless you
are using bi-wiring with the utmost highest grade so far
you could find. e.g. One set of Emperor crown (latest and
most advance version now ) and one set of Emperor G6
these two are recomended to me by Siltech's dealer in Hong Kong ( which is for upper and Lower I mixed up, but they
recomend this way is better than 2 sets identical )

But I am satisfied with single-wiring with the best Jumper'sets ( may be the budget is too far high if more
up-grading )

You should try Jormadsign No1 biwire cables, they are true biwire cables, using two sets of wires.

Hey Teddy bear!

Right now I'm using the Virtual Dynamics Revelation 2 as singlee wire and they are already two completely discrete cables. I'm planning to get one more so I have four discrete cables going to each speakers.

Regards,

Michael