2. analog
  3. 1322606082

Using a DD table as motor to drive another table

I have an old Denon DP-52F turntable. After reading the thread about turntable speed, I have a newfound respect for accurate and consistent speed.

It occurs to me that I could modify my old DD Denon to drive the platter of my SME 10 table via a thread drive. I have to get out the old table to see if it has variable/adjustable speed, but could this idea work?

I could just listen to the Denon and compare it to the SME, but the cartridge, arm and wiring are all different. The SME should be the superior table in most ways, but the direct drive of the Denon has me intrigued. Has anyone tried something similar? What are the issues involved and how should I get started? If the two platters have the same diameter, the speed should be close, hence the importance of variable speed on the Denon for any minor speed adjustments. Any advice would be greatly appreciated.
peterayer
hifiharv
351 posts
 
This would be a very interesting experiment. But, think about the bearing on the DD table. It probably was never intended to take the side load imparted upon it while driving another platter by belt. Only the downforce of a balanced platter spinning. I'm doubtful that you will actually improve the sound of the SME in this way, but, it would be fun. Maybe on a lesser table, the results could be an improvement.
casey33
260 posts
 
If you google Roscoe Primrose and look on his DIY page you can see a similiar set up
lewm
13,104 posts
 
One of the benefits of driving one platter with another is reduction of belt creep, and if you do it with a thread, there are fewer of the other issues associated with BD. Everyone who does this swears by it, but we all swear by all the things we either pay big bucks for or that require a lot of effort, as in this case. None of this is true scientific experimentation, but so what.

Just make sure the Denon is really operating up to its max. To do that, you might ought to change out all the old electrolytic capacitors in the Denon for new ones. And then, in the case of any Denon, you are going to have to do some cutting, I think, to enable your thread drive to encircle the Denon platter, since the edge of the platter is not so accessible, and the platter itself was never made to be encircled by a thread or belt (i.e., no groove).
hiho
451 posts
 

My previous post was intended to say "VHS is the only interface I tried so I CANNOT vouch for others."

Fat fingers. :-)

_______
stanwal's avatar
stanwal
3,147 posts
 
Rube Goldberg rides again! As Harv says it will still be belt drive and the SME has a very good belt drive already. I have seen this done but usually using a much more massive belt driven platter as a flywheel to drive a second platter by a second belt. Too much trouble for me but if you feel like it try it.
More to discover