Vibration and Isolation at a budget?

Evidently not.

I don't mind though.

Thanks for the replies. With all this, what would be the priority of each of these?

Again, here's what's set:

1) Sand filled speaker stands
2) 2 inch maple platform for TT with brass cones
3) Built in points on amp

Now, priority questions on these.

1) Cones, big fat dots for speakers? even with sand filled?
2) Anything else for TT?
3) Anyting else on Amp?

Or, just get some big fat dots (or similar) on speakers and sub. Though, with the new era gold v, not sure if the sub will be needed anymore.

And to David12: I'm a little older going into school then others, so I've been able to build up a couple systems over the past few years. And, this system is in the music room/study, so I'll be in here a good bit as you know. And, any extra time will be spent with the wife and dogs. Thanks for the "good luck". Luckily for me, I've been running at Pathology/Histology lab at Emory Univ. so the usual Histology nightmares shouldn't be too bad for me...I'm more worried about Pharm.

Thanks,
Paul

Put your brass cones on the TT and four soft mounts like Sorbothane, Vibropods or IsoBlocks (in order of soft to not so soft) between maple and Salamander. At those prices you can experiment. Brass cones under Era with a weight on top. Remove sand from stands and put in a bag of the largest lead shot you can get from a gun supply shop in each stand before replacing what sand will fit. Put cones between speaker stands and floor. Be sure that cones pierce carpet if you have any. Ditto for sub. Get rid of the amp and buy a guitar. ;-)

I am looking into isolation products as well.

Sorry if I am highjacking this thread.....

I have a Blue Circle BC27 phono stage for audition now and if I raise the volume high enough, there is this very low frequency energy being reproduced by the speakers.
My Pro-Ject Tube Box MkII phono stage does not do this either with rumble filter on or off.
I suspect few things as being the cause of the problem:
1) The problem is feedback and not really a turntable rumble per say;
2)the table isolation;
3)BC27 stage reproduces these lower frequencies and Pro-Ject attenuates them.

I have my table simply on the top shelf of a Salamander Archetype 2 and there is nothing in between the shelf and the table. Table, a Pro-Ject Xperience, has stock cone feet.

Am I correct in my assesment of the problem?
How can this be cured?
If the isolation is the cause, would a Mapleshade platform with isoblocks be more or less effective than, say, Ginko Cloud 11?
Thanks!

isolation on a budget

probably more than you want to spend but
Silent Running Audio VR series stands took my amp, cd and preamp to new levels

their OHIO series is anything but budget
and when you get out of med school you can afford a CRAZ rack