VPI 2nd Pivot for 3D

Here's the link to the video in situ.
http://www.marklevinson.com/productdetail/~/product/no515.html

@moonglum may be correct as the video of the needle drop is of an Ortofon 2M Bronze (I think) whereas the 515 ships with (and is seen later in the video) with a Cadenza Bronze which looks quite different

all in all this is coming off like amateur hour by Mark Levinson and VPI

Dear @folkfreak : It's obvious that the tonearm in that you tube video is an unipivot design or a gimball one with a severe extreme bearing damages.

The video is a " dramatization " that helps to understand what is happening in continuious way at microscopic stylus tip during play of any cartridge in any unipivot tonearm design and in little lower way in quai-unipivot ones.

Forces are so huge that gravity alone can't correct it.


Regards and enjoy the MUSIC NOT DISTORTIONS,
R.

"It has been experimentally shown that with such high pressures and forces of friction between stylus and the vinyl, that the outer skin layer of the record material melts as the tip slides over the plastic and then refreezes almost as fast as it melted. It has been suggested that since the melting temperature of vinyl is about 480 °F (248 °C) that the same temperature exists in the contact area.”

Thank you again very much Raul for supplying the biggest laughs I am getting this week this claim is absolutely astoundingly extraordinary and it is obviously intended NOT to be taken seriously perhaps as a lesson that we should not believe everything we read or perhaps as a lesson that "fake news" is not a new phenomenon! It should be patently obvious to anyone with even a limited understanding of thermodynamics or who even knows how to operate a common household thermostat that a record does not go from room temperature to melting to freezing (!!!!) all in an instant simply because a stylus passes over it. While I suppose a conjecture could be made and it is only a conjecture that a stylus may heat a record due to friction but to suggest that it will melt the vinyl and then FREEZE It is beyond silly it is so funny thank you, Raul!

What would be really great is if we could capture those FREEZING temperatures and conduct them in such a way to offset the heat produced by our tube amplifiers! That would be great especially in the summer months Raul will you please use Google to see if that can be done and then cut and paste cut and paste and cut and paste and cut and paste cut and paste and cut and paste and cut and paste and cut and paste some more and share that with us??? Thank you and thanks again for the big laughs you made my day your stuff gets funnier and funnier.

The many versions of VPI arms that can use pivot damping fluid are very stable, and have no wobble.

I have heard the 3D arms, and they have nothing over a properly setup metal VPI arm, IMO!

The 3D arms look cheap!

The new second pivot "supposed improvement" is simply "expectation" bias - nothing to shoot out about.

stringreen is a long time VPI shill!

I like VPI, but I am not "mad" about all their newer products.