VPI Classic 3 vs Basis 2200

I currently own a Basis Debut with an outboard motor controller and vacuum clamping system. The build quality is exceptional. Unlike some other tables where you can see slight play or out-of-round "wobble" in rotating parts, absolutely nothing of that sort can be seen with the Basis.

But, I have also owned a VPI HW15-IV and it too is quite a nice table. Yes, it is not built quite as well as the Basis, but it is a lot cheaper and worked well for many years (it is currently in a friend's system still working away).

I don't think you can go wrong with either brand.

Lots of fine sounding tables out there - I have only owned Basis in my vinyl reincarnation. I have heard many great tables at shows but that must be taken with a grain of salt versus played in your own system. I just think in general vinyl sounds so much better - I can tell within seconds if it is digi or vinyl when I walk in a room.

I was fortunate, my dealer started me out with a Basis 1400 sig that knocked me out of digital forever...or at least the last several years.

I upgraded to the 2200 sig and can't imagine buying another table. It is a music maker. AJ at basis offers terrific support.

Thanks again everyone. Any opinions on the Synchro-Wave Power Supply? I spoke with A.J., seems like a really great guy, and he feels that it's a very big plus.

Moryoga I have heard the synchro-wave makes a huge difference but this comes from a basis dealer and also AJ....I know it is expensive - I have been a little reluctant to add one to my 2200....perhaps I am being cynical but I can't grasp getting that much more for that investment.

I have a synchrowave and it makes a difference, though I would hardly consider it to be a major improvement. Pitch stability is good with Basis tables without a separate power supply so what one hears is not so much related to obviously better pitch stability than one hears a more "solid" (weightly without sounding bloated or sluggish) sound and sharp imaging.

It is the real deal when it comes to power supplies. In order to use it, the motor for the table has to be sent back to Basis for modification. That is because the power supply does not merely use a capacitor to split the power for the dual phases being fed to the motor like some power supplies do.

The really cost effective upgrade with their tables is buying their top grade belt. This might actually make a bigger difference (particularly if the belt on the table is worn).