VPI Prime Sig/Lyra Delos / Feedback ...help!

Hello all, strange one here...just picked up a VPI Prime Signature Rosewood and a Lyra Delos with about 20-40 hours on it...sounded great at low volume with my sacred Steely Dan - Aja Cisco pressing . Later that night at higher volumes I'm getting a midrange-low feedback . 

Here's my rig : 

VPI Prime Sig with Unipvot / Lyra Delos 0.6m output voltage / 1.75 tracking force

Allnic 1202 Phono Pre (variable DB boost  +22, +24 , +28, +32) 

Manley Snappers / Jumbo Shrimp Pre 

Harbeth 40.3XD 

So I A/B'd w the old turntable VPI Prime Scout / Unipivot / Hana ML 0.4 Output and all was fine 🤔 I then swapped arms moving the Hana to the Prime Sig , no feedback ....🤔

I've tried adjusting the Allnic (all 4 levels mentioned above) and get feedback with the Lyra on every setting...

The hifi business I purchased from said they had tested thoroughly and had 0 problem with it ...so I'm perplexed , this doesn't seem to be any vibration feedback , is the Lyra just not jiving with my Phonostage for some reason? 

Any help appreciated ...




Thanks for the info ....again strange because not only does VPI use the Lyra mention in their manual for the Prime Signature model, I hear consistently it’s a go to for VPI tables...

Might be the 3D printed arms don’t do as well with Lyra on wood floors etc... ..🤷🏻‍♂️


My direct experience was with a Lyra Clavis Da Capo and a Skala.  Both were defocused and thin sounding on the VPI JMW 12 on an Aries Extended (original).  On a "custom built" table using original VPI TNT components and a Jelco TK-850L, both opened up, had great tonal body and remarkable imaging and soundstage. 

Maybe the VPI / Lyra recommendation is associated with the gimbaled arms.




Later that night at higher volumes I'm getting a midrange-low feedback

@tommypenngotti Since this is volume related it leads me to think the turntable isn't well isolated from room/air -borne vibration. If it were me I'd be looking at things to improve its isolation- better feet, an anti-vibration platform, that sort of thing.

I know you don’t want to hear this but 

a current driven  phono stage like the little Loco by Sutherland will in essence set itself.  I’m running a Lyra Delos through 

the little loco and it’s pure magic. Sooo

if your phono stage is the culprit I would look at a trans

Current driven phono stage

good luck Willy-T