2. analog
  3. 1197421321

VPI Super Platter

From what I read here and at AA it appears the general consensus is that the Super Platter is a fairly significant upgrade from the all acrylic platters on the newer Scoutmaster and Aries turntables. However, I have an older Aries 1 with a fairly heavy platter that resembles in appearance, the Super Platter. Any Aries 1 owners know the one I am talking about? Would the Super Platter be as significant an upgrade to this platter as it is to the acrylic ones? Also, does the inverted bearing that comes with the Super Platter represent a significant improvement over the bearing I already have. My Aries is about 6 years old and has the JMW 10 tonearm. I also have the SDS.
randyhat
dgarretson
2,597 posts
 
A little creative destruction should remove that ball. I would drill a hole through the ball and drive in a stud remover. Or thread the hole in the ball and insert a grade 8 bolt, which could be extracted together with the ball by using a puller. Some light heat from an acetalene torch might also help. If it can be pressed in, it can be pulled out.
ptmconsulting
1,000 posts
 
I received an e-mailed suggestion that I'll have to give a try (thanks Markd51). Basically he suggests I dry off the shaft and ball, then take a hard dry rubber mat and try to turn the pressed in ball so the wear spot is not on the pivot point. Just press the ball down on the rubber matt and try to move it with force.

Smart idea. I'll have to give it a shot and see if it works.

Thanks again,
Bob
ptmconsulting
1,000 posts
 
Nope. Didn't work. This little ball is really pressed in tight, or perhaps machined out of the whole bar of steel and not a separate ball at all. It is not going to turn or loosen, not now, not ever.

I guess I've got what I've got.

Again, anyone hot a MK IV platter and bearing they want to part with?

Bob
More to discover