2. speakers
  3. 1236449879

What amp are you using with your Gallo 3.1's?

I bought a pair of Gallo 3.1's in September. I am currently using a Response Audio Platinum modified Jolida 502b with KT88/98 tubes, 60 watts per channel. Input tubes are vintage Tungsol and Valvo. I am, for the most part (audionervosa) satisfied with the sound. Timing, rythm, and pace is good, the sound is happy, toe tapping fun. Very musical. I had a Mcintosh 6900 for a cpl of months 200 watts with autoformers. I was dissapointed that there seemed to be no synergy with these two components. The sound was rolled off, flat, and lifeless in my system, in my house. YMMV

I am just curious what other Gallo owners have tried, what worked well, what didn't, and what you are using now.
leatherneck1812
leatherneck1812 OP
116 posts
 
Thanks for the info Dave. I am a carpenter/cabinet maker and I am going to make better stands anyway so the speakers aren't so easy to tip. I will copy Mapleshade and buy their footers.
Russ
dopogue
1,773 posts
 
Leatherneck, you need to know that Mapleshade uses only 4 of the 6 bolts holding the speaker to its base (the front 2 and the back 2). Also they use threaded brass studs and contoured brash washers between the speaker and the base that hold the speakers approximately 1/16" above the bases. This may sound unimportant but after hearing them, I would recommend ignoring it.
leatherneck1812 OP
116 posts
 
Dopogue,

What do you mean "contoured brass washers" I get that they seperate the bases from the speakers by the thickness of the washer, but they are they something other than flat brass washers?

Thanks,
Russ
dopogue
1,773 posts
 
Visualize one of those brass washers with a "shoulder" on it, often found under the heads of brass wood screws. Sorry, that's the best I can do. :-)

Each of them is mounted "with the concave side upwards toward the speaker enclosure (i.e., so it "catches rain")." I'm quoting from the assembly instructions.
leatherneck1812 OP
116 posts
 
Are the brass studs threaded into the wood or into a machine threaded insert?
More to discover