What are the best tube amps for Klipschorns?


I hav a pair of Klipschorns and a pair of LaScalas used together. With sensitivity of 104dB each, these don't need much power. I have a 125wpc Mark Levinson 334 ss amp now that has to be attenuated 20dB before it reaches the preamp. I'm after the bass punch and extreme detail of the ML, but in a lower powered, lower weight tube amp.
redwoodgarden
At the risk of being accused of picking a fight with God, I respectfully disagree, Atmasphere. :-)

We have paired our Klipschorns with quite a few different amplifiers (Quicksilver, Audion, George Wright, McIntosh, Art Audio, etc.), both tube and SS. We happen to enjoy both. Yet there are distinct differences between them, particularly when it comes to the impact and definition of the bass, where SS has bested tubes every time. In addition, the SS lends a greater sense of speed and separation to the music, whereas tubes excel at humanizing tone. Does SS have the emotional impact that the tube amps do? No, not to my ear. On the other hand, while tubes/Klipschorns are distinctly more engaging during active listening, SS sounds remarkably more even and cohesive from anywhere outside the listening room, save perhaps a solo instrumentalist. When listening to Led Zeppelin, Frank Zappa, U2, or even big band, despite the fact that a 1W amp will drive the speakers to ear-bleeding volume level, the SS amp (we pair ours with a tube preamp) is much better at approaching lifelike dynamic heft than any tube amp I have tried, even 60W or better.

So it's settled...we need two systems!
You may want to consider the best of both worlds. An amp like the HK Citation II @ 60 wpc. It has solid state rectification with tube output. These amps give the great bass punch that you get from SS combined with the warm, revealing mids that you get with tubes. Good compromise choice.
No, its even simpler.. Top end and mids maybe should have low power tubes for best dimension, and Big bass drivers should have solid state.. This seperates power supplies, and frequency demands of the weak points on both technologies, well its not perfect, but as close as we can come with a little experimentation.. I will be running my full range hopefully in the next 2 weeks with Pure Class A tubes on the mids up, and my Bass Line arrays on 700 watts of Solid state... In order to get that type of power and control on woofers for about 100 hz down would seem that it is a waste of time, money, Heat and Dozens of tubes to do what a cheaper solid state can do to take full control of bass drive for no heat, very little money, and just as good of tone down low, pure reliability with plenty of impact.
Thanks for your replys guys!!!!!!

Boa2,
I was wondering what tube pre amps you've paired with a SS amp & Klipschorns and the results you've encountered?

Thanks.
Andre74,
Of the tube preamps we've tried, we like the Lamm LL2 Deluxe most. It is not for the analytical listener, in my opinion, because you distinctly hear the music and not signature of the component. Reviewers describe it as organic sounding, and I would agree. Like great musicians, I tend to lean toward audio components that are so good at playing to the song that they don't stand out in the group.

Hope that helps.