What is the best arm for a Linn Soundeck 12

roksan nima, a poor man's aro, is supposed to work well on an LP12. availibility in the US may be an issue, though.

Gracias Raul, and thanks Gordon. My system is quite humble. Have the LP12 with an Audiotecnica AT440MLA cartridge, which I was thinking in replacing. Also have a Dennon DL 103 which is brand new and can dispose very easy. The Linn is presently playable and have no hurry because the skip happens on very few albums. Therefore, I have quite a bit of time. I just want to get something that offers good value and good sound. I have looked at the arms posted in AG and found that it is almost better to buy a another TT and put the Linn on the block.

Juan as far as differnt armboard drilling locations for each arm I would again consult a Linn Dealer. If you want to be safe I would stay with Linn. Keep in mind any arm you re-mount on there other than a Akito will most likely require you have the suspension adjusted.

I am fixing up an older Linn and am replacing the Grace 707 [which is a good match] with a Jelco 750D. Some non Linn arms will use the same cut out as Linn,check specs on Vinyl Engine. I have used the Ittok, it is a good arm. I chose the Jelco to make it easier to change cartridges, as this is going to be a second table I was willing to give up a little performance for convenience.

You'll do just fine with the Ittok LV II. There is more of a difference between the Basic and Ittok than the Ittok and Ekos.
I use a Dynavector 10/5 MC with the Ittok. You can use your same armboard if staying with Linn. Also, so far, the the lengths are the same for each arm, so a custom Mint LP will be an excellent tool for mounting a cart. If you switch up to the Ekos, you can still use the mint LP.