What is the best arm for a Linn Soundeck 12

Gracias Raul, and thanks Gordon. My system is quite humble. Have the LP12 with an Audiotecnica AT440MLA cartridge, which I was thinking in replacing. Also have a Dennon DL 103 which is brand new and can dispose very easy. The Linn is presently playable and have no hurry because the skip happens on very few albums. Therefore, I have quite a bit of time. I just want to get something that offers good value and good sound. I have looked at the arms posted in AG and found that it is almost better to buy a another TT and put the Linn on the block.

Juan as far as differnt armboard drilling locations for each arm I would again consult a Linn Dealer. If you want to be safe I would stay with Linn. Keep in mind any arm you re-mount on there other than a Akito will most likely require you have the suspension adjusted.

I am fixing up an older Linn and am replacing the Grace 707 [which is a good match] with a Jelco 750D. Some non Linn arms will use the same cut out as Linn,check specs on Vinyl Engine. I have used the Ittok, it is a good arm. I chose the Jelco to make it easier to change cartridges, as this is going to be a second table I was willing to give up a little performance for convenience.

You'll do just fine with the Ittok LV II. There is more of a difference between the Basic and Ittok than the Ittok and Ekos.
I use a Dynavector 10/5 MC with the Ittok. You can use your same armboard if staying with Linn. Also, so far, the the lengths are the same for each arm, so a custom Mint LP will be an excellent tool for mounting a cart. If you switch up to the Ekos, you can still use the mint LP.

Best LP12 I've heard so far was Aro/Keel with power supply upgrade.

John C.