What is the Best Tool to Measure Cartridge Azimuth?


What do you use to measure / set azimuth of your cartridges and / or styli? I am afflicted with diminished eyesight, so aligning the azimuth of the stylus by eye is not practical.

To that end, I’ve use a simple bubble level (spirit level) about 1-1/2” in diameter to get the headshell as close to level as possible, after first leveling the platter by adjusting the turntable feet. 

I figure some clever lever engineer has made an easy to use electronic tool for this purpose, but I haven’t found anything in my searches. Nature abhors a vacuum, so one day if not already, it might surface. 

Until then, does anyone have alternate methods? How about using a test record? Is that feasible? I do have a couple of good oscilloscopes by the way, so I can make precise measurements of levels, phasing, frequency, etc.... 
128x128sleepwalker65
Have we become so enamored with technology that we have neglected the best tool: our EARS?

First, it is easiest to set azimuth if you have a tone arm that makes it easy.  Generally the VPI tonearms do NOT make it easy unless you use the dual pivot.  IMO the dual pivot makes it crazy easy.

Then, using a small flashlight shine it on the front of your arm and cartridge and make a horizontal line on the cartridge/arm parallel to its reflection on a record.  That is your starting point; do a lot of listening.

Then using your fine azimuth adjustment, move VERY slightly in one direction.  Listen for a while, and if better continue with small movements in that direction until one of those settings gives you the most spread and separation.  If worse, do the same in the other direction.  If both worse, stay at level.

Best of all, your ears are free!
melm, I hate to say it, but for stuff like this, the ears are woefully inaccurate.  To begin with, most of us do not have equal acuity in both ears, not to mention equal frequency response sensing, and not to mention room effects, etc.  And then there's the brain...
However, I also have no beef with just sitting the cartridge squarely at 90 degrees to the LP surface.  This is a recent and radical change of thinking for me.

While setting up my Garrard today, my friend Rick had brought round his Fozgometer and test l.p. ( amongst other essential tools!) to be able to set azimuth.

I decided to just set it 90 degrees to the LP instead just as I always have done.
Maybe one day but I think I am close enough to enjoy the music as is.