what to do cordless phone amplifier problem


Hi,

I have mono amps where one of the two mono amps has intermittent interference from static which comes out of one of the speakers. I did a variety of tests to rule out as the source of the problem: the speakers, the preamp, the cd player, the speaker cable, and the interconnect cable. I also tried grounding the amplifier as well as power conditioner. I sent the amplifier back to the manufacturer and the manufacturer says the amp works fine.

Today, my wife tried to use the cordless phone in the downstairs bedroom and instead of getting a dial tone she got the sound of my stereo blaring through the cordless phone receiver. She then noticed that this same thing happened on the kitchen cordless phone too.

I assume that the problem with phone picking up my stereo signal is linked to my intermittent static issue.

Since its happening on two separate cordless phones on two different floors of the house(same phone number though), should I be calling a electrician or the phone company to check out the phone lines?

The problem does not occur continuously. The phenomena lasted for about 10 minutes.

Any thoughts?

Michael
128x128karmapolice
Weird. Cordless phones do come in different varieties. If you have the 900mhz flavor, try the 2.4 ghz flavor (be careful of interference with wireless computer network, however). Or try the 5 ghz flavor.

- Eric
I have a feeling that Eric is correct. The 2.4 ghz cordless phones are notorious for generating interference, especially with microwave ovens. I have experienced that myself, and now only allow the 5.8 ghz phones in the house. The 900mhz is a solution as well, though the range is not as good as the 5.8 ghz models. I believe that there was an article about all of this in "Consumer Reports" a few years ago.
First did you switch the amps and did the static go to the other speaker?? If so, it is in the amp, if not... keep switching IC and PC, if it never switches, call the electrician.

Drtmth58, as for rage I must differ, I have found as each new cordless phone comes out touting better range the range actually diminishes. My older 900 mHz phone would work fine on the beach from my condo, when I 'upgraded' to a 2.4 GHz, it no longer worked on the beach. When I bought my house (sorry to lose the beachfront but..) I got a 5.8GHz phone, damn thing doesn't work in the driveway!!!
KennyT,

I did switch the amplifier but the static remained coming out of the same speaker. When I sent the one amplifier back to the manufacturer, in the interim I ran the remaining mono amplifier and an old mono amplifier I had lying around and never had the static problem. Now the mono returned from the manufacturer and the problem returned.

All the problem phones are 5.8GHz.

So do people think I should call a electrician or someone to look at the phone wires in the wall?

Mike