What type of wire for dedicated 20A AC lines?
I’m about to have two 20A dedicated lines installed. What type of wire should I use? I know there are differences of opinion on whether to use 10 AWG or 12 AWG, however the link below makes a great case for using even 8 AWG solid core copper on longer runs like mine will be (50 ft), to ensure a lower resistance, lower voltage drop over the long run, and therefore more access to instantaneous current for my Gryphon Diablo 300. The wire would need to be stepped down to 10 AWG to connect with the receptacle. The article actually states that the thickness of the wire is more important than the fact that it is dedicated…
Assuming I want to follow this advice, which again makes sense to me, where would I find such wire to give to my electrician?
I agree! FWIW: My four dedicated lines are not on the same electrical phase at the breaker panel. The best sounding configuration in my rig is what I posted above. Mike
|
OP, I think you have made a good choice… I put in another direct line last year. I had the electrician use 10 gauge romex. It made a nice difference. I think it is important to move on these things one at a time… make each prove they were worth it. There are so many possible improvements, each can be a learning experience. Go hog wild when the last three things you did to your power really impressed you and you are now convinced major surgery will produce further gains. |
@nyev :
Good decision. Best of luck with the project and install. IMO, the peace of mind alone by doing 10 AWG, no regrets down the road, is totally worth the extra two hundred bucks, regardless of whether it makes a difference in theory or practice
|
Here’s a question about the work my electrician is about to do: is there any creative way I can isolate the AC noise that our tenants generate from our lines? Our tenants have their own breaker panel that is fed off of our breaker panel. Someone above suggested a particular filter device to deal with noise coming into the whole house. My fear however is that this could do something to the tonal balance that I’d be stuck with. Filters can do that. But, I was wondering if such a device could isolate our AC lines from our tenants, on the tenant’s side of the breaker so it doesn’t impact our lines? Or maybe there is another way to isolate their AC from ours?
|
