Amplifier's end means where the output transformer goes to ground, I think.
I'm a little confused.
"Increasing main capacitance will reduce impedance but also reduce self resonance point. It might be necessary step to combat ripple but does nothing to improve frequency response needed to lower the noise or improve load response."
"Increasing main capacitance will reduce impedance but also reduce self resonance point. It might be necessary step to combat ripple but does nothing to improve frequency response needed to lower the noise or improve load response."
So, because I have film power supply caps which are nearly double the capacitance than specified in the original schematic and have very low ESR being film caps, you're saying I really don't need to worry about reducing ripple as much? Then how do I improve the frequency response needed to lower the noise or improve load response? (How does improving frequency response lower noise or improve load response?)
Do film caps in general have higher self resonance than electrolytics?
I'm going to use 0.1 microF Mundorf M-Cap Supreme as bypass caps, which are noninductive. But I have no idea what the self resonance point of these caps. Do these seem like a good choice for intended purpose?
Sorry, lots of questions, I know.
I'm a little confused.
"Increasing main capacitance will reduce impedance but also reduce self resonance point. It might be necessary step to combat ripple but does nothing to improve frequency response needed to lower the noise or improve load response."
"Increasing main capacitance will reduce impedance but also reduce self resonance point. It might be necessary step to combat ripple but does nothing to improve frequency response needed to lower the noise or improve load response."
So, because I have film power supply caps which are nearly double the capacitance than specified in the original schematic and have very low ESR being film caps, you're saying I really don't need to worry about reducing ripple as much? Then how do I improve the frequency response needed to lower the noise or improve load response? (How does improving frequency response lower noise or improve load response?)
Do film caps in general have higher self resonance than electrolytics?
I'm going to use 0.1 microF Mundorf M-Cap Supreme as bypass caps, which are noninductive. But I have no idea what the self resonance point of these caps. Do these seem like a good choice for intended purpose?
Sorry, lots of questions, I know.