Which amp for B&W 805 D3 and HTM2 D3 speakers - Rotel RMB-1555?


I am setting up a system with L&R of 805D3 and Center of HTM2 D3. My understanding is that just the receiver (plan on getting Onkyo TX-RZ50) will not power these speakers well enough to get the most out of their potential. I am thus considering adding a Rotel RMB-1555 for the LCR. I would maybe consider bi-amping L&R since RMB-1555 is 5 channel. My question is whether the RMB-1555 (120W x 5) is sufficient or would there be a significant improvement in going to RMB-1585 (200W x 5). I do not listen to the music too loud. Just want clarity. Per B&W, the recommended amp for 805 D3 is 50W - 120W into 8Ω on unclipped program.

While you are advising me on RMB 1555 vs 1585 for this set-up, I am open to other options in the price range as well.

Thanks

someet

By the way, I am driving my 805 D3 bookshelves with 1000 watt monoblocks.  You don't really buy high power amps because you are gong to use all that power.  You buy hi power amps to get the largest power supply.  This ensures smoothest and strongest sound even at low to mid listening levels.

So, that being said, the 1585 would give you a little bit beefier bass/midbass response when compared to the smaller 1555.  It could also have a smoother response in the mids as well and could give you extended depth of soundstage, but you are spending considerably more.  It all depends on your budget point.  Both are Class AB amps and have a very nice sound.  The Rotel Class AB is voiced just very tiny bit on the warm side, but still has excellent response.

If you wanted a more neutral high resolution amp, maybe look at ATI AT4005 (retail $4495).  It is considerably more expensive, though.

Rotel will still be extremely good and very pleasant to listen to.

The smaller 1555 could start to run out of gas on movies when you start turning up the volume pretty high.

If I were doing it, I’d look at: Classe (used), Bryston (21B) or Maybe even 2 Pass Labs XA30s (Bi amp the center channel).