You never know what today will bring

Oddly enough, even Discovery Essence RCA interconnects seem to have a lower SNR (than other RCA interconnects) because I also tend to turn DOWN the volume knob a couple of notches when I use Essence RCA IC's between my CDP and pre-amp.

This is compared to other IC's such as Shunyata, Aries; Coincident, CTS; and HT, Truth Link. Go figure.

Balanced circuits are 6 dB or twice the voltage. Double the perceived loudness is 10 dB measured in SPL at the speaker.

The Electrocompaniet CDP is a true balanced design, as is the Pass Labs X-1 Pre that is next in the chain.

I have been swapping in new PCs as well. Since I do not have dedicated line I have a ground loop problem which I currently correct by floating all but one of my components. I have noted that polarity (which way I plug the floated PCs into their outlets) affects output SNR as well.

From published measurements I have seen over the years, there is no 'exactly' or 'always' about these things. But we don't as yet know whether Judit's CDP is a true balanced design throughout, or just uses a splitter circuit to give a 'balanced' output. If it is truly balanced, than that will be the reference output level, and a single-ended output will be lower in level, maybe by closer to the 6dB figure than if it is not truly balanced (most CDP's are not). The common-mode noise rejection has mostly to do with the RFI/EMI picked up on the connecting cable. But I'm like you on these matters - definitely open to correction! The main thing is if Judit prefers the sound with the new connection.

Huh? I thought that true balanced operation output is ALWAYS EXACTLY 6dB higher as the "equal" signal "halves" are summed, which is exactly +6dB, and has NOTHING to do with reduced noise due to common-mode rejection. Oh well, maybe I'm wrong here? Wouldn't be the first time....

Actually, the difference in output between single-ended and balanced connection will vary depending the gear in question, but the increase with balanced is more typically on the order of about 3dB or so (6db means twice as loud), which sounds more in line with Judit's experience of having to turn down two 'clicks'. It is true that the common-mode noise rejection will improve by up to about 6dB.

Yeah Ernie, but think of the benefits. If I sold Subarus for you, everyone would get more for less.

Teacher, Judith forgot to do her maaaath!

TWL is correct. The difference between single-ended and balanced is indeed +6db. The same thing would happen if you switched from single-ended to balanced between your preamp and amp.

Yes, Judit, the balanced connection has a +6db difference, if I remember correctly.