Harwood Flooring Information For Dedicated Room

Nothing beats the look and solidness of real 5/8" or 3/4" hardwood nailed or glued down. Either way, you will have a nice soild floor. On the other hand, floating engineered or laminate flooring tends to be noisy (just tap on it) since it is thin and de-coupled the sub-floor.

There is a special underlay product that reduces noise and is used in appartment buildings - I'd recommend that to dampen vibration - it is expensive though and the floor will need to be glued down. I think a live end can sound nice if you have an acoustically dead end around and behind the listener. The product will raise the wood floor considerably and you can therefore use a thick underlay under the carpet too...the more absorption the better.

On my 1st level floor I used 1" T&G Oak nailed on 1" plywood laid over 2x6 T&G doug fir over 12" joists on 16" centers. On the second level I used 1" T&G oak over and nailed to 1" plywood which was screwed and glued on 10" joists on 16" centers. Virtually no floor flex on either level. FWIW.

Try using engineered Bamboo or Cherry nailed and glued. If you use solid hardwood like Oak or Cherry do not glue to the subfloor because it expands and contracts during different times of the year. I would also use a wider board like 4" to 5" instead of the smaller 2".

Screw and glue the subfloor like NewBee suggested. If you cannot glue the subfloor make sure you double up on screwing the subfloor down to the joists. If you have squeaks in the subfloor you can search for special fasteners that help eliminate the squeak.

First and foremost , screw the subfloor every six inches along the floor joists . Stagger the pattern from joist to joist. Start 3 inches away from the wall on the first joist then six inches away from wall on second joist then back to 3 inches then six again . DO NOT use drywall screws . Buy the proper screws . This is not overkill but properly done . The special underlay spoke of previously is a higher performance of the years back when waxed paper was used . The newer material offers some but limited dampening or vibration control . It,s main job is to eliminate the possibility of squeeks occurring through natural shrink and expanding of real hardwoods . When laying any floor the first layer is more importantly done properly as it is the foundation your finish floor sits on . By screwing the subfloor down properly you tie it in firmly with all the joists as if it was now one peice or slab . Real 3/4 inch hardwood is the best for durability and as stated the laminates are thin and noisier . Also never never glue down a real hardwood floor !! It must be able to expand and contract freely with the seasons or it will split crack and squeek . The glue will stay put the wood will not . Laminates can be glued but myself I never recommend them unless thats what people insist on . They don,t last as long and if there is a need or a want to remove them , because they are glued the subfloor is ultimately damaged as well . The floating floors for a room to use as your dedicated sound room I would not recommend .Laminates floating or glued are best used for basements, laundry rooms and bedrooms . Ultamately because the hardwood will not go more than 8 inches past the front of the speakers the carpet will play a bigger roll in affecting the sound . You stated tentavily . I have had and those I have installed floors for as well have had better results for a listening room with a complete hardwood floor then using some area rugs . Cheers