Richard,
My tonearm wiring also runs outside of the wand. There is a photo of it in my system page.
My tonearm wiring also runs outside of the wand. There is a photo of it in my system page.
Eminent Technology ET-2 Tonearm Owners
Where are you? What mods have you done ?
I have been using these ET2's for over 9 years now.
I am still figuring them out and learning from them. They can be modified in so many ways. Bruce Thigpen laid down the GENIUS behind this tonearm over 20 years ago. Some of you have owned them for over 20 years !
Tell us your secrets.
New owners – what questions do you have ?
We may even be able to coax Bruce to post here. :^)
There are so many modifications that can be done.
Dressing of the wire with this arm is critical to get optimum sonics along with proper counterweight setup.
Let me start it off.
Please tell us what you have found to be the best wire for the ET-2 tonearm ? One that is pliable/doesn’t crink or curl. Whats the best way of dressing it so it doesn’t impact the arm. Through the spindle - Over the manifold - Below manifold ? What have you come up with ?
- ...
- 2371 posts total
Courtesy of Chris, here is a composite pic of my ET showing the wiring arrangement. The current arrangement is the same, except that I am now using the original/lighter aluminum arm wand instead of the magnesium with wrap shown in the pic. Also, the damping trough is now disengaged, and I have added a fridge magnet for damping. http://cgim.audiogon.com/i/vs/i/f/1364852043.jpg |
Richard, the only time that I have not had the wiring on the outside was during the first two years or so that I had the arm (about twenty years ago!) when it was wired internally with VDH silver. I changed the wiring (Cardas) to reap the benefits of using a continuous run from cartridge to preamp. At the time, I did not consider the possibility of benefits due to the sheer fact that the wiring would be external. The improvement in sound was very significant, but I attributed it to the elimination of several solder joints and connectors along the signal's path. I have since changed the wiring two more times; Discovery, and currently AN which is my favorite by far. |
Frogman. 20 years! It gets scary when you start thinking back doesn't it? I also have a continuous run to the pre but put it inside purely for cosmetic reasons. My thoughts would be to route it such that it stands off from the wand a little. In theory there would still be some interaction between wand and wire, due to proximity. That said, the level of this may be just too tiny to notice. Have you per chance tried this? |
- 2371 posts total