Porter Ports are installed, but have to report that they don't hold the power cords any better than the outlets I replaced.Markpao,
07-23-12: Markpao
Just curious.... Did you install the receptacles with the equipment ground up?
.
- ...
- 34 posts total
Yeah, I tried that way first. Then turned it around after I saw it backed out just the same. I think now after spending more time with this, that the problem is more to the fact that the power cords are so stiff, than the actual weight of them. Like I mentioned, I have them molded so the floor actually supports them and keeps them fully plugged in now. Thanks for all your help. |
Hey Markpao I can't find the thread but there was an A'gon member here who used fishing line to help support his beefier power cords. Another gent I met used really thick pipe insulation to help support his power cords so they wouldn't slip from the receptacle. He measured the distance from the floor to the outlet cords, cut the pipe insulation and put it right under to prop it up. Since the outlets were behind his gear no one could see the propped up cords. I'm curious too about 3 or 4 prong power cords and the special receptacles they require. I see this kind of cord and outlet with servers and dryers. Since there is a market for these big and beefy power cords in the audio community why it hasn't been attempted to use these types of locking receptacles etc etc. |
While we're on the topic of droopy power cords, I would also mention that some of my power cords also sag down a bit on the female end in my component sockets as well. In particular my VooDoo Silver Dragon. I'll bet if some power cord manufacturer came up with a high end twist lock with matching outlets they would get some attention. Not sure how they would address the female end at the component though. Hey, wait a minute, my wife works at an attorneys patent office. I wonder.......... |
I'll bet if some power cord manufacturer came up with a high end twist lock with matching outlets they would get some attention. Not sure how they would address the female end at the component though. Hubbell manufactures exactly what you describe, and since it's already UL approved the expense of having it certified is already taken care of. I use the cryo version in my own system to accommodate 240 Volt for Euro gear. It's a great sounding combo and works with 125V and 240V up to 30 amp. Here's the male at Amazon rather than the Porter Port version. Hubbell twist lock |
- 34 posts total