To bridge or not to bridge....


I have a Bryston 4B ST and lately have been red lighting.
So I want to bump up my power.
What is the best way to go?
Add another 4B St..bridged?
Buy separate mono blocks..it doesn't have to be Bryston.
What is the difference,if any, with mono blocks over a pair of bridged 4B ST?
Or stay with a single amp with more power?
I have always found this to be very confusing.
The cheaper way to go would be another 4B ST.
I will update my speakers later.
Any info/direction would be greatly appeciated.
thefalls1117
My speakers are Kef 104.2..92 db..4 ohm and they have a single binding post only.
I have contacted Bryston,regarding this problem,on the off chance there is a technical fault.
Haven't heard anything yet.
Thanks ,so far, for the info.
Yep, the truth is there that your unit needs to be checked.
Good to have 20yrs transferable warranty though!
Bryston replied "very unlikely that there is a fault.Amps usually work or they don.t.
I guess I'm under powered or need hearing aids.
First of all how hard are you driving the system? Do you turn you volume above 3 o'clock?
Did you check if your speakers can handle 600W/ch(I believe that bridged Brystons 4b-st through such wattage in 4Ohm or even more)?
I've owned the 4bst and 7bst and found that the former could play very loud without red lighting. I liked the sound and punch better with the 7bst regardless of usual listening volumes. I can't recall turning my preamp up more than the 1 o'clock position since it got really loud much before that.

It didn't occur to me before, but you said that the problem is only recent. Two questions: 1) Does your orange (or is it yellow?) light come on before the red does? 2) Does everything sound the same before as it does now? Maybe your warning light system is bad. If you are listening at the same volumes (both position on the dial and perceived db level) as before and the only difference is that the red light comes on now, maybe it's the light. You might want to ask Bryston about that. Also, you might want to carry the 4bst to a friend's place or your dealer and plug it into his/her system. See if and when the light comes on there? If the amp's OK somewhere else, maybe the speakers have a problem and the impedence has dropped. Just a few thoughts.