Question for those with experience in biamping:
I bought a second pair or Krell fbp 750mcx, a Pass XVR-1 and interconnects/cables to biamp the Dunlavy SC-VI. I will use the extra set of Krell exclusively for the 4 x 15 woofers.
The passive crossover circuit for the parallel 15 drivers has a series inductor of 6.8mH (first order crossover), and then a RC circuit (Zobel for impedance equalization) with R= 0R37 (6x 2R2 in parallel) and C of 220uF.
When I biamp with the new set of 750mcx, should I: (i) remove only the inductor and leave the parallel RC, or (ii) remove also the parallel RC?
Of course I can try both alternatives, listen and measure, but I would like your opinions.
I bought a second pair or Krell fbp 750mcx, a Pass XVR-1 and interconnects/cables to biamp the Dunlavy SC-VI. I will use the extra set of Krell exclusively for the 4 x 15 woofers.
The passive crossover circuit for the parallel 15 drivers has a series inductor of 6.8mH (first order crossover), and then a RC circuit (Zobel for impedance equalization) with R= 0R37 (6x 2R2 in parallel) and C of 220uF.
When I biamp with the new set of 750mcx, should I: (i) remove only the inductor and leave the parallel RC, or (ii) remove also the parallel RC?
Of course I can try both alternatives, listen and measure, but I would like your opinions.