Amp heat sinks are ringing


I have been working to reduce the slap echo in my room by using quick hand claps, and various foam panels to attenuate the noise. I have discovered that my Classe CAM 200 monoblock heat sinks are actually ringing- they can be excited by handclaps, and heard across the room. There are 10 heat sinks per amp, about 2" deep by 8" high. Running my fingers along the heatsinks makes them ring like a bell!

I am concerned that this ringing might be excited when I am listening to the system, and may add extra treble noise.

Does anyone have any suggestions for damping out the noise? I am concerned about using a material that can withstand the heat, and not impede the airflow?

thanks for your help!
gnobber
You may want to try placing some "felt-type" pads between the heatsinks on your amps. This should damp out some of the ringing and cost you next to nothing! However, there are probably better and more effective methods that may cost more.
Gnobber, how hot do the heatsinks normally get? If they stay cool - than you can play with some damping material. But if they run hot, anything you place on or around heatsinks will impede cooling and can cause damage to the output devices. Perhups, placing the amp in the separate room and running the cables to the speakers through the wall may be an answer.
I had the same problem with a CA300 and I used MDF blocks the same length and width of the heat sinks and placed on top of the fins and then weighted down with brass cones. I painted the MDF black so it didn't look bad. The fins never got hot enough to mar the paint or the wood and the difference was dramatic, much better focus and imaging and reduced some of the glare spots through the treble.
You also try the opposite of Rhljazz's recommendation. Put the blocks under the fins so the weight of the amp rests on the blocks instead of the feet. That way the heat from the fins could rise and escape more easily than if the top is blocked. You could also try several strips with spaces between so air could get in between them. I am not familiar with your amp and don't know if the fins can hold the weight so I would proceed with caution.
I guess some of you don't realize how heat sinks work. They cool the amp by natural convection which means VERITCAL air flow around the fins. If you put blocks under (or over) the fins, you are destroying the convective flow and raising the sink temperatures exponentially. Your hand my not feel a big difference but your transistors will.

I would contact Classe and see what they have to say about this problem. If they aren't helpful, you may want to try loosening the heatsinks just a little teeny bit. It may be tough to get at mounting screws but if you can, loosen them a very little bit - no more than half a turn or else your thermal resistance from case to sink will rise too much. In no way should the sinks feel loose at all after this - if so tighten them back up some. Otherwise, you may be able to think of a way of cramming a thin piece of metal between every other pair of fins that wouldn't obstruct airflow appreciably but puts the fins in a bind. Anyway, for such an expensive amp, Classe should tell you how to fix it. I wouldn't accept no for an answer. Good luck - Arthur